auszookers.com
https://auszookers.com/forum/

Replacing pinion bearing
https://auszookers.com/forum/viewtopic.php?f=5&t=8487		 Page 1 of 1
Author:  Red_October [ Tue Dec 08, 2009 2:53 am ]
Post subject:  Replacing pinion bearing
Does the center need to be removed in order to replace the pinion bearing?
Author:  steak_knife [ Tue Dec 08, 2009 3:01 am ]
Post subject:  Re: Replacing pinion bearing
Red_October wrote:
Does the center need to be removed in order to replace the pinion bearing?


Yes... and then the center need's to be set up again by some one with the know & tool's, while it's out you may as well put all new bearing's in it.
Author:  Red_October [ Tue Dec 08, 2009 3:07 am ]
Post subject:  Re: Replacing pinion bearing
aaah. I just got both centers rebuilt and now the rear is leaking no less than one day after installing everything. Now i've got to take the center out again and drop it off for them to fix.
Author:  atari4x4 [ Tue Dec 08, 2009 3:09 am ]
Post subject:  Re: Replacing pinion bearing
drive it there... show them the leak, leave it there & get them to fix it.
Author:  steak_knife [ Tue Dec 08, 2009 3:13 am ]
Post subject:  Re: Replacing pinion bearing
atari4x4 wrote:
drive it there... show them the leak, leave it there & get them to fix it.


X2!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! :P
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/