auszookers.com
https://auszookers.com/forum/

to machine fly wheel or no to
https://auszookers.com/forum/viewtopic.php?f=5&t=8491		 Page 1 of 1
Author:  banga [ Tue Dec 08, 2009 10:24 am ]
Post subject:  to machine fly wheel or no to
im putting in a new motor this weekend and was just wondering if i should the get the fly wheel machine the new motor im putting has an auto box so the fly wheel on it should be alright.
Author:  oozuk [ Tue Dec 08, 2009 11:24 am ]
Post subject:  Re: to machine fly wheel or no to
no flywheel in an auto box, it's called a flex plate and no you don't machine it just bolt it together
Author:  Scrawny [ Tue Dec 08, 2009 12:28 pm ]
Post subject:  Re: to machine fly wheel or no to
If you are fitting a manual with new clutch then definately get the flywheel machined. But as oozuk said, no flywheel in auto boxes.
Author:  mike.knew [ Tue Dec 08, 2009 7:01 pm ]
Post subject:  Re: to machine fly wheel or no to
I just had a new clutch put in. $100 to get the fly wheel machine and makes this cool whirl noise when you ride the clutch 8)
Author:  steak_knife [ Tue Dec 08, 2009 11:10 pm ]
Post subject:  Re: to machine fly wheel or no to
mike.knew wrote:
I just had a new clutch put in. $100 to get the fly wheel machine and makes this cool whirl noise when you ride the clutch 8)


Reminding you not to ride the clutch!! :roll:

I had a flywheel do that after a machine, drove me crazier. :P 8O :? :lol: 8) :roll: :wink:


& what Scrawny said :P
Author:  banga [ Wed Dec 09, 2009 10:23 am ]
Post subject:  Re: to machine fly wheel or no to
yeah i found that out yesterday arvo that the auto dont have a fly wheel the same as the manual. i was going to definatley machine the one off the manual i was just tryin to see if i could get it all ready for the weekend. 100 bucks is dear for a flywheel to get machined last time my mate did his in his subaru it only cost 30 thanks for your imput
Author:  ball [ Wed Dec 09, 2009 10:34 am ]
Post subject:  Re: to machine fly wheel or no to
banga wrote:
yeah i found that out yesterday arvo that the auto dont have a fly wheel the same as the manual. i was going to definatley machine the one off the manual i was just tryin to see if i could get it all ready for the weekend. 100 bucks is dear for a flywheel to get machined last time my mate did his in his subaru it only cost 30 thanks for your imput



That is about right to have it done correctly. You should pay around $70-$100 to have the flywheel ground.

If it was just faced off in a lathe it may be cheaper but it isn't the right way to do it.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/