| auszookers.com https://auszookers.com/forum/ |
|
| HJ80 Engine replacement https://auszookers.com/forum/viewtopic.php?f=5&t=8505 |
Page 1 of 1 |
| Author: | Hunter308 [ Tue Dec 08, 2009 11:26 pm ] |
| Post subject: | HJ80 Engine replacement |
Hi this maybe covered somewhere else but a mate of mine has a '75 hj80? and needs to replace the 800cc engine, will a 1.3litre fit? any suggestions welcome cheers Carl |
|
| Author: | Ben_Sierra [ Tue Dec 08, 2009 11:35 pm ] |
| Post subject: | Re: HJ80 Engine replacement |
Can we clear something up... we are talking about an LJ80 (suzuki) here, not an HJ80 (landcruiser), correct? If so... Dunno bout a 1.3 but a 1.0 definitely does. Bolts straight up just about. |
|
| Author: | Hunter308 [ Wed Dec 09, 2009 12:25 am ] |
| Post subject: | Re: HJ80 Engine replacement |
Hi sorry about that yes it is a LJ80. thanks for the quick reply and i will pass on the infomation |
|
| Author: | hutch [ Wed Dec 09, 2009 12:30 am ] |
| Post subject: | Re: HJ80 Engine replacement |
Yes the 1.0 block/head is the same as the 800cc. You will need to use the 800cc sump and oil pick as the 1.0 sump will hit the steering relay rods. You will also need the 800cc distrubutor as the 1.0 leans more to the top and the bonnet hits it. It is a straight forward swap. 20% more power! 
|
|
| Author: | steak_knife [ Wed Dec 09, 2009 12:38 am ] |
| Post subject: | Re: HJ80 Engine replacement |
Hunter308 wrote: Hi this maybe covered somewhere else but a mate of mine has a '75 hj80?
and needs to replace the 800cc engine, will a 1.3litre fit? any suggestions welcome cheers Carl Yes a 1.3 will fit, with lot's of cutting & shutting of eng mount's on the chassis. Worth it in my opinion as parts for 1.3 are more readily available. |
|
| Author: | 2stroker [ Wed Dec 09, 2009 3:37 am ] |
| Post subject: | Re: HJ80 Engine replacement |
Hutch is correct re fitting a 1 litre. 1300 is a good way to go but a lot more modifications to make it fit, if you go 1300 there are sump to diff clearance problems to overcome as well, also you will need the 1300 gearbox as the belhousings are not the same, gearbox crossmember will have to be cut out and a new one fabricated, gear stick will come out in a different place and interfere with the heater. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|