auszookers.com
https://auszookers.com/forum/

gearbox output shaft
https://auszookers.com/forum/viewtopic.php?f=5&t=8546		 Page 1 of 1
Author:  Saam [ Thu Dec 10, 2009 9:14 pm ]
Post subject:  gearbox output shaft
can i get to the output shaft bearing (the one that could cause play on the output shaft) without taking the gearbox out, or would i be mad even trying it.
Author:  303zuke [ Thu Dec 10, 2009 9:27 pm ]
Post subject:  Re: gearbox output shaft
No, because even though it's the rear bearing for the output, it's actually about halfway in the case and clamped between the upper and lower cases and retained by a ring in a groove. The only way to get it out is to separate the upper and lower halves of the case.
Author:  want33s [ Thu Dec 10, 2009 10:20 pm ]
Post subject:  Re: gearbox output shaft
I have a disassembled box here Sam if you want to look at what's involved.
Author:  Saam [ Fri Dec 11, 2009 12:47 am ]
Post subject:  Re: gearbox output shaft
okay no worries jas I'll let you know :)
Author:  Saam [ Fri Dec 11, 2009 12:49 am ]
Post subject:  Re: gearbox output shaft
anyone know if any of the bearings from a leafy transfer case as the same as that bearing in question in the gearbox ? because i have a set of bearings and i whole transfer.
Author:  want33s [ Fri Dec 11, 2009 2:46 am ]
Post subject:  Re: gearbox output shaft
They are damn close but I couldn't say for sure they are the same.
Author:  303zuke [ Fri Dec 11, 2009 3:30 am ]
Post subject:  Re: gearbox output shaft
As I mentioned, this bearing has a ring and groove to retain it. The ID of the bearing is pressed on to the output shaft and the ring retains the bearing (and therefore the shaft) in place. Without the ring locking into the groove on the bearing, the whole bearing and shaft float right on out the back of the box. You could use an ordinary bearing (I think it's either a 6206 or 6306), but it MUST have the groove. Ask CBC for the actual bearing number, they will likely have on in stock on the shelf.

But why are you only replacing one bearing in the box? Why not do 'em all?
Author:  Saam [ Sun Dec 13, 2009 10:59 pm ]
Post subject:  Re: gearbox output shaft
303zuke wrote:
As I mentioned, this bearing has a ring and groove to retain it. The ID of the bearing is pressed on to the output shaft and the ring retains the bearing (and therefore the shaft) in place. Without the ring locking into the groove on the bearing, the whole bearing and shaft float right on out the back of the box. You could use an ordinary bearing (I think it's either a 6206 or 6306), but it MUST have the groove. Ask CBC for the actual bearing number, they will likely have on in stock on the shelf.

But why are you only replacing one bearing in the box? Why not do 'em all?


there is a bearing with a retaining ring like that in the transfer case. thats why i was asking if they where by chance the same size.

i don't have an income and i am trying to hunt down a vibration, the only place i can see it coming from now is the output shaft.. so if i had a bearing i was just going to swap it out and see how i go.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/