| auszookers.com https://auszookers.com/forum/ |
|
| Gear oils/ Flush ideas??? https://auszookers.com/forum/viewtopic.php?f=5&t=8560 |
Page 1 of 1 |
| Author: | v.w.dave [ Fri Dec 11, 2009 5:33 pm ] |
| Post subject: | Gear oils/ Flush ideas??? |
SO last weekend my breathers all got ripped off and both diffs, Trany and T-case filled with water. And seeing as I didnt know it happend my rear diff is now at reast (R.I.P.) I have drained the milkshake out of the rest. Now I am going to hope there is no major damage in the rest of the drive train (FINGERS CROSSED) The Question I have is should I flush them all out with something??? If so what have you tryed before??? I was just going to get some cheap gear oil and run it for a few days then drain it out. Or do you just fill it up and go on with your day? I normaly run Castrol 80W-90 as I get it cheap. Any past expierance would be a help. |
|
| Author: | lump_a_charcoal [ Fri Dec 11, 2009 5:40 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
Yeah run some cheap gear oil for a few days, then drain it out. That is what I have done in the past... |
|
| Author: | BlueSuzy [ Fri Dec 11, 2009 5:46 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
yep. x2 |
|
| Author: | eldo [ Fri Dec 11, 2009 6:22 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
maybe ask the castrol rep what he reccomends? |
|
| Author: | royce [ Fri Dec 11, 2009 6:25 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
fill it with kero and run run it on a hoist for a bit to clean up the shit and refill it or dont bother, the small amount left in there after you drain it wont matter |
|
| Author: | SuziBlu [ Fri Dec 11, 2009 7:12 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
Go the kero. |
|
| Author: | Rockhopper [ Sat Dec 12, 2009 1:06 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
royce wrote: fill it with kero and run run it on a hoist for a bit to clean up the shit and refill it
or dont bother, the small amount left in there after you drain it wont matter x3 |
|
| Author: | lump_a_charcoal [ Sat Dec 12, 2009 3:56 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
Kero will get into the grease and remove it too, no? |
|
| Author: | Rockhopper [ Sat Dec 12, 2009 8:36 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
there should'nt be any grease in the tranny or tansfer case |
|
| Author: | lump_a_charcoal [ Sat Dec 12, 2009 9:05 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
In my rebuild instructions it says to put grease on the roller bearings... |
|
| Author: | royce [ Sat Dec 12, 2009 9:40 pm ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
I would say thats so they arent running dry straight up till oil gets flung to em kero is a lubricant as well so should be ok |
|
| Author: | jimbo_jones [ Sun Dec 13, 2009 12:20 am ] |
| Post subject: | Re: Gear oils/ Flush ideas??? |
just drain it and refill will be fine theres no need to flush like royce said the small amount left in there wont matter |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|