auszookers.com
https://auszookers.com/forum/

N/T Drover Drag Link?
https://auszookers.com/forum/viewtopic.php?f=5&t=8671		 Page 1 of 1
Author:  mightyrollaman [ Wed Dec 16, 2009 3:00 am ]
Post subject:  N/T Drover Drag Link?
Nice easy one for you.....hopefully.

Where's the best place to get a cheap replacement drag link for my Drover?

Mine is banana shaped after playing at Yalwal all weekend.

I'm probably happy to go standard again.
Author:  want33s [ Wed Dec 16, 2009 3:30 am ]
Post subject:  Re: N/T Drover Drag Link?
Buy a new one from any decent parts shop
OR
strengthen yours by adding a piece of 4mm thickwall tube around it.
I reinforced mine with some tube I cut in half lengthwise and welded around the draglink.... haven't had a problem with it since... :wink:
Author:  weaves [ Wed Dec 16, 2009 5:02 am ]
Post subject:  Re: N/T Drover Drag Link?
I did the same with 3mm rhs.

Also did the draglink at the same time. Haven't had a problem since.

started out like this
Image
and finished like this
Image

ps. please dont laugh at my welding. :lol:

weaves
Author:  squirezook [ Wed Dec 16, 2009 2:07 pm ]
Post subject:  Re: N/T Drover Drag Link?
:rofl: :rofl: :rofl: :rofl:
Just kidding as long as it holds who gives a stuff were not all boilermakers
Author:  mightyrollaman [ Wed Dec 16, 2009 10:10 pm ]
Post subject:  Re: N/T Drover Drag Link?
Thanks fellas.

I'm thinking of staying stock though. to minimise the likelihood of the failure point becoming one of the rod ends, which would be a considerably more dramatic failure!

I'd very much prefer to limp home with a bend rather than a snapped rod end!

Or am i being overly cautious?
Author:  want33s [ Wed Dec 16, 2009 10:46 pm ]
Post subject:  Re: N/T Drover Drag Link?
Mine is twin locked, runs 32" Centipedes and I give it a hiding. Never broken a tie rod end or even heard of a Zook rod end breaking.

Image
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/