auszookers.com
https://auszookers.com/forum/

OME Front Spring Difference
https://auszookers.com/forum/viewtopic.php?f=5&t=8865		 Page 1 of 1
Author:  Shaggy [ Sat Dec 26, 2009 10:02 pm ]
Post subject:  OME Front Spring Difference
Finally ready to attempt the install of my new suspension kit and just realised there are 2 different springs for the front?
They are OME and are labelled
CS013FA
CS013FB

Obviously one is for the drivers side but anyone have any idea which is which :?: :?:
Physically they look both the same and side by side there is no difference however i guess they must have been set differently.

No indication on the invoice (Even the quote had them listed as seperate parts) etc to which is which and being the holidays ARB aren't open till Tuesday. Was hoping to make a start before then.
Thanks
Jason.
Author:  appsie [ Sat Dec 26, 2009 10:26 pm ]
Post subject:  Re: OME Front Spring Difference
A should be the drivers side mate.But sit em up on top of each other and one will have a greater arch.Thats the drivers side to allow for the battery,you,spare wheel etc

have fun with it :wink:
Author:  Shaggy [ Sat Dec 26, 2009 10:30 pm ]
Post subject:  Re: OME Front Spring Difference
:D
Thanks Appsie
Got it in one, I looked at them every which way etc but never closely side by side.
Once you suggested A is the drivers side you can see it is slightly raised, maybe only 20/30mm in it.

Other than driving it in the mud what else would you do on a wet boxing day. :)

Thanks once again.
Author:  appsie [ Sun Dec 27, 2009 2:26 am ]
Post subject:  Re: OME Front Spring Difference
not work on cars haha.enjoy the day a bit more than that.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/