| auszookers.com https://auszookers.com/forum/ |
|
| Aftermarket tacho https://auszookers.com/forum/viewtopic.php?f=5&t=9513 |
Page 1 of 1 |
| Author: | mightymouse [ Fri Jan 29, 2010 9:07 pm ] |
| Post subject: | Aftermarket tacho |
 Can anyone out there help, I am about to fit an aftermarket tacho as my dash one seems to have a mind of its own at times. I thought seeing as I have one laying around I might as well fit it, is there any idiosyncracies with 1.3 sierras ignition that I should be aware of. 
|
|
| Author: | MrRocky [ Fri Jan 29, 2010 9:40 pm ] |
| Post subject: | Re: Aftermarket tacho |
its dead easy 4 wires, earth, accessories, power/light? and signal which comes of one side of the coil. |
|
| Author: | dank [ Sat Jan 30, 2010 12:42 am ] |
| Post subject: | Re: Aftermarket tacho |
Yeah I had to find my tacho wire the other day. From memory its the black with orange or red trace that goes into the coil. |
|
| Author: | mightymouse [ Sat Jan 30, 2010 1:10 am ] |
| Post subject: | Re: Aftermarket tacho |
thank you gentlefolk I was sure that it would not be too difficult but b etter to be thought a fool than go ahead stuff it up and prove it with out doubt  
|
|
| Author: | 89_tintop [ Sat Jan 30, 2010 1:53 am ] |
| Post subject: | Re: Aftermarket tacho |
if you want to mate you can pick up all you need off the back of the dash cluster.. saves running wires everywhere. |
|
| Author: | ZookiMonsta [ Sat Jan 30, 2010 1:59 am ] |
| Post subject: | Re: Aftermarket tacho |
89_tintop wrote: if you want to mate you can pick up all you need off the back of the dash cluster.. saves running wires everywhere.
thats what I did with mine, and its all apples. just broke out the old test light and pulled the plug on the back of the cluster and tested each wire when I turned on my parkers etc. pretty straight forward. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|