Remove the bolts through the springs at the shackle end, drop the end of the spring to the floor, remove the bolts holding the shackle to the chassis, bolt the stock shackle to the chassis, bring the spings back up and bolt into the shackle.
Easy.
| auszookers.com https://auszookers.com/forum/ |
|
| EXTENDERED SHACKLES BACK TO STOCK https://auszookers.com/forum/viewtopic.php?f=5&t=9808 |
Page 1 of 1 |
| Author: | carlgarson [ Fri Feb 12, 2010 12:32 am ] |
| Post subject: | EXTENDERED SHACKLES BACK TO STOCK |
What is the best way to swap them back |
|
| Author: | Taff [ Fri Feb 12, 2010 12:35 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
Its just a matter of taking the extended out and putting the stock ones in. 15 minute job to do both sides. Only 4 bolts. |
|
| Author: | Ben_Sierra [ Fri Feb 12, 2010 12:36 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
Remove the bolts through the springs at the shackle end, drop the end of the spring to the floor, remove the bolts holding the shackle to the chassis, bolt the stock shackle to the chassis, bring the spings back up and bolt into the shackle. Easy.
|
|
| Author: | carlgarson [ Fri Feb 12, 2010 12:58 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
Ben_Sierra wrote: Remove the bolts through the springs at the shackle end, drop the end of the spring to the floor, remove the bolts holding the shackle to the chassis, bolt the stock shackle to the chassis, bring the spings back up and bolt into the shackle. thank you
Easy. |
|
| Author: | Choppy [ Fri Feb 12, 2010 1:02 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
Taff wrote: Its just a matter of taking the extended out and putting the stock ones in.
15 minute job to do both sides. Only 4 bolts. hopefully it does only take 15min i remember when SI3RR4 and i changed his springs, sometimes those damn bolts just dont want to budge. but yes fairly simple procedure |
|
| Author: | Taff [ Fri Feb 12, 2010 1:10 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
A highlift makes this a very easy job because you can get the car just in the right spot so there is no load on the shackles at all. then everything slides apart real nice. |
|
| Author: | Red89 [ Fri Feb 12, 2010 1:14 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
Doing both sides at the same time helps as well. Take both drivers and Pass. side extended shackles off and then put the stock ones back on. |
|
| Author: | steak_knife [ Fri Feb 12, 2010 1:17 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
Taff wrote: A highlift makes this a very easy job because you can get the car just in the right spot so there is no load on the shackles at all. then everything slides apart real nice.
But you have to hit some thing with a hammer, just cause it make's you feel tough & in control. 
P.s. Easy job |
|
| Author: | Taff [ Fri Feb 12, 2010 1:24 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
Im always tough and in control, i dont need to hit things with a hammer to get that feeling. |
|
| Author: | stuzuki [ Fri Feb 12, 2010 1:25 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
its amazing how good you feel after hitting something. |
|
| Author: | Choppy [ Fri Feb 12, 2010 1:30 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
stuzuki wrote: its amazing how good you feel after hitting something.
haha this comment could easily be takin out of context if u have a disturbed mind such as mine . . . ps definalty do both at same and use jacks, takes all tension off shackles |
|
| Author: | Taff [ Fri Feb 12, 2010 6:51 am ] |
| Post subject: | Re: EXTENDERED SHACKLES BACK TO STOCK |
I dont know about you Al but i feel fantastic. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|