auszookers.com
https://auszookers.com/forum/

T-Case help!
https://auszookers.com/forum/viewtopic.php?f=5&t=9817		 Page 1 of 1
Author:  Ben_Sierra [ Fri Feb 12, 2010 4:23 am ]
Post subject:  T-Case help!
I've just finished putting my spare case back together with my 4.16 gears in it and I've hit a bit of a hurdle...

I decided to give it a trial run in the back yard before swapping the cases over, everything spins fine, it shifts between 4-Lo and 4-Hi no dramas, but I can't get it to shift into 2-Hi..

Any ideas?? I really want the gears in for the weekend!
Author:  just_cruizin [ Fri Feb 12, 2010 4:27 am ]
Post subject:  Re: T-Case help!
Shifter shafts not lined up properly, put it in 4H pull the shifter out and line up the grooves in the shafts
Author:  Ben_Sierra [ Fri Feb 12, 2010 4:32 am ]
Post subject:  Re: T-Case help!
I assume that the two cut-outs in the shafts need to be together, is that right?

I may have to leave it til morning now... But I'll give it a try....

Any other suggestions just in case it isn't that?
Author:  v.w.dave [ Fri Feb 12, 2010 4:50 am ]
Post subject:  Re: T-Case help!
just_cruizin wrote:
Shifter shafts not lined up properly, put it in 4H pull the shifter out and line up the grooves in the shafts


Nahh mate Just Cruizin hit it spot on. You have it out of sink. pull the shifter out use a screw drive to make the gates both lined up at the engine end of the hole. Put the shifter back in and away you go.
Author:  11_evl [ Fri Feb 12, 2010 1:18 pm ]
Post subject:  Re: T-Case help!
Won't the middle detent ball stop that from happening.
More like the shifter was put in in the wrong gate to start with??!!!
Author:  Ben_Sierra [ Fri Feb 12, 2010 3:11 pm ]
Post subject:  Re: T-Case help!
Thanks for the help guys :D
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/