& drain you gear oil out of the box, so when your pulling the g/box out you don't end up covered in it..
| auszookers.com https://auszookers.com/forum/ |
|
| Replacing clutch - what else should I do https://auszookers.com/forum/viewtopic.php?f=5&t=9898 |
Page 1 of 1 |
| Author: | pyrohamish [ Mon Feb 15, 2010 11:09 pm ] |
| Post subject: | Replacing clutch - what else should I do |
Ok I've ordered a replacement exedy clutch kit, what other parts should I replace while I've got everything it out? |
|
| Author: | Brett [ Mon Feb 15, 2010 11:20 pm ] |
| Post subject: | Re: Replacing clutch - what else should I do |
thrust and spigot bearing (in the flywheel) do your rear main if its on the way out and get the flywheel machined up for the new clutch |
|
| Author: | steak_knife [ Mon Feb 15, 2010 11:41 pm ] |
| Post subject: | Re: Replacing clutch - what else should I do |
& drain you gear oil out of the box, so when your pulling the g/box out you don't end up covered in it..
|
|
| Author: | buzbox [ Tue Feb 16, 2010 12:14 am ] |
| Post subject: | Re: Replacing clutch - what else should I do |
Have the flywheel machined. In my last car, I had the casting on the back of the flywheel machined off, kinda making it like a lightweight flywheel. It definitly revved out easier. 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|