[kyzermattingley]

As mentioned I have the following stuff to get rid of, pic to follow

1- modified bundera housing, axles etc -all brackets removed from housing, housing then ground smooth, axles have been redrilled (by Driveline Services) to suzi 5stud pattern with new studs fitted, comes with Jimny front disks that I was using to do a disk brake rear conversion, comes with bearing cups and other bits and pieces.
$200ono. Willing to weld on brackets / shave pumpkin / brace / disk brackets for more $

SOLD2- Sierra transfer to Jimny jig -puts the transfer about 30mm higher and 30mm further forward, I used this to make my brackets for my Sierra transfer into my Jimny, fits better than other kits on the market
$100onoSOLD

SOLD3- ARB locker wiring, front locker switch and pump switch -the box is just missing the diff centre
$25 SOLD

4- hilux complete front diff -wheel to wheel, not sure what ratio centre, have all the parts to convert to hi-pinion with rear mounted toe rod
$150

5- LROR Suzuki to Toyota diff conversion flanges -Suzuki tail shaft pattern to Toyota diff pinion spline, used for putting Toyota axles into your Suzuki
$50ea. Or $80pair

SOLD6- Jimny front diff brackets -front diff brackets that I plasma cut from a Jimny diff housing
$10SOLD

7- Toyota 4.1 hi-pinion 8" front diff centre -removed from an 80series front diff, great condition, never got around to using
$100


Location- Murarrie, Brisbane, QLD

CONTACT- Brett 0433191205

Willing to ship stuff at your expense

[dougies_tx5turbo]

Mate will take 1 ,2 and 6 pm sent and I well txt in the morning and can pick up tomorrow Monday afternoon thank Doug
Edit maybe take all the staff needed to convert to jimny front and rear

[Sookie]

Hey mate I'll take locker wiring and switch ect

[Zook_Fan]

In for the locker wiring etc. if Sookie pulls out.

[nick_bj40]

I'm keen on the high pinion centre but how much would freight be to nsw 2526?

[kyzermattingley]

Lockers switches and wiring sold