| auszookers.com https://auszookers.com/forum/ |
|
| Vitara CALMINI 3 inch front coils. Darwin. https://auszookers.com/forum/viewtopic.php?f=7&t=22166 |
Page 1 of 1 |
| Author: | Timbo_ [ Sun May 22, 2011 6:20 am ] |
| Post subject: | Vitara CALMINI 3 inch front coils. Darwin. |
Average condition, no real damage, just slight rust where springs have touched each other as paint has been removed. Nothing some sandpaper and some paint wont fix. Offer close to 3 inch lift with no front bar or light front bar. Looking at bit over 2 inch lift with front bar. My strenthened ARB bar as well as anvi and skid plates has taken its tole on them so i have replaced them. Make an offer by PM if interested. this is the height they give. Slightly lower than the rear. Please not my driveway isnt level to begin with.
|
|
| Author: | HDOGG [ Sun May 22, 2011 9:39 am ] |
| Post subject: | Re: Vitara CALMINI 3 inch coils. Darwin. |
Hey. Is it just the fronts ??? |
|
| Author: | Timbo_ [ Sun May 22, 2011 9:00 pm ] |
| Post subject: | Re: Vitara CALMINI 3 inch coils. Darwin. |
yep |
|
| Author: | jesse_vit [ Wed May 25, 2011 10:26 am ] |
| Post subject: | Re: Vitara CALMINI 3 inch front coils. Darwin. |
going solid in the front end? |
|
| Author: | Timbo_ [ Thu May 26, 2011 8:35 am ] |
| Post subject: | Re: Vitara CALMINI 3 inch front coils. Darwin. |
No, just replacing shagged coils with some brand newies. |
|
| Author: | Polar_Bear [ Thu May 26, 2011 2:47 pm ] |
| Post subject: | Re: Vitara CALMINI 3 inch front coils. Darwin. |
Timbo_ wrote: Average condition Timbo_ wrote: no, just replacing shagged coils
So are they average or shagged? |
|
| Author: | Timbo_ [ Thu May 26, 2011 11:23 pm ] |
| Post subject: | Re: Vitara CALMINI 3 inch front coils. Darwin. |
They are perfectly fine for anyone running little to no front bar. I assumed they where completely gone by the way my car has been sitting like a drag car. But my front chassi only sits another 30mm higher than that with the old ones fitted. So i probably will just keep them as a spare at the rate these are selling. Going a winch soon. So things where going to get heavier up the front again. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|