auszookers.com
https://auszookers.com/forum/

[NSW] 5 spoke Jimny alloys - set of 5 - $400 (make an offer)
https://auszookers.com/forum/viewtopic.php?f=7&t=35576
Page 1 of 1

Author:  tim80z [ Sat Sep 08, 2012 5:35 pm ]
Post subject:  [NSW] 5 spoke Jimny alloys - set of 5 - $400 (make an offer)

As the title says, I have a full set of Jimny 5 spoke alloys for sale. Two have no tyres on them at the moment, two have a pair of almost bald 215R15 Bridgestone RD-604 Desert Duellers and the last one has an almost new 205/70R15 Bridgestone Dueller H/T on it.

The H/T tyre is as good as new and has travelled just under 100kms. The desert duellers are almost bald and have started to get some small cracks in the sidewall, I will remove these from the rims if the buyer doesn't want them.

All rims are in good condition. A few have some minor marks that would be able to be removed with a bit of elbow grease. One rim has a small scrape mark (see photos).

Rims are 15x5.5 and a quick measurement tells me they have an offset of +6.

Also included is a pair of rear hub covers to suit.

Located in Parkes NSW (about an hour west of Orange or an hour south of Dubbo).

Price was $500 now $400 or nearest offer.

Group shot.
Image

Indvidual close ups.
Image
Image
Image
Image
Image

215R15 Desert Dueller tread. (5%)
Image

205/70R15 Dueller H/T tread. (99%)
Image

Some rims have minor marks from tyre fitting. They should clean up with a bit of elbow grease. Note the cracks in the side wall of the Desert Duellers.
Image

One rim has a small chunk missing on the outer lip.
Image

Rear hub covers.
Image

- Tim.

Author:  tim80z [ Tue Sep 11, 2012 2:48 pm ]
Post subject:  Re: 5 spoke Jimny alloys - set of 5 - $500 ono

bump.

Author:  tim80z [ Thu Sep 13, 2012 2:03 pm ]
Post subject:  Re: [NSW] 5 spoke Jimny alloys - set of 5 - $400 (make an of

Make an offer.

I need these gone as I have no further use for them and need the extra cash to help get me to Fraser in November.

- Tim.

Author:  tim80z [ Sat Sep 15, 2012 5:18 pm ]
Post subject:  Re: [NSW] 5 spoke Jimny alloys - set of 5 - $400 (make an of

I got some wheel boxes today so I can pack these up ready to send via courier. Each box is 46cm x 46cm x 22cm and will weight about 8kg with a wheel in it.

- Tim.

Author:  Scales [ Sat Sep 15, 2012 5:45 pm ]
Post subject:  Re: [NSW] 5 spoke Jimny alloys - set of 5 - $400 (make an of

gotta say im tempted Tim! If just to get you to Fraser! but I'd get my ass kicked to next tuesday since i have a set of alloys under my carport already.... wanna swap? lol

Author:  tim80z [ Sat Sep 15, 2012 6:15 pm ]
Post subject:  Re: [NSW] 5 spoke Jimny alloys - set of 5 - $400 (make an of

I'm almost certain I'll be able to make it to Fraser. If I can move these or my old M13A then I should be able to lock it in.

There's been a bit of interest in these on eBay so I'm hopeful that will translate into bids. No interest in the M13A so far though.

- Tim.

Author:  tim80z [ Sat Sep 15, 2012 6:35 pm ]
Post subject:  Re: [NSW] 5 spoke Jimny alloys - set of 5 - $400 (make an of

So I had an enquiry from a member asking if I would consider delivering to Brisbane/Gold Coast as I paas through on the way to Fraser Island in November. I said I would consider it based on the following conditions:
  • Wheels only, no tyres. Just to save space in the back of the Jimny while traveling there, I'd cover the cost of removing the tyres on them now.
  • 50% deposit. A 50% non refundable deposit up front would be required to protect me in case I drive them all the way to the Gold Coast and then you change your mind and I have to cruise around Fraser with 5 extra wheels in the back. 8O
  • Delivery fee. I'm not asking for you to cover delivery all the way but I would be going at least a little out of my way to deliver them so a small delivery fee would be appreciated.

I am happy to extend this offer to anyone else. I will be passing through Sydney, Newcastle and then up the coast to Brisbane so I can deliver anywher along there (within reason).

- Tim.

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/