auszookers.com
https://auszookers.com/forum/

G16a engine for sale possible blown head gasket QLD
https://auszookers.com/forum/viewtopic.php?f=7&t=39440		 Page 1 of 1
Author:  Twappett90 [ Wed Mar 06, 2013 11:07 pm ]
Post subject:  G16a engine for sale possible blown head gasket QLD
Hey guys

I've got an old g16a 8v engine with carby minus distributor
Has done 280000 Km

It does run, a bit rough tho has an oil leak from the front crank seal I think.

Thinking it may have a blown head gasket as it was using a bit of coolant and couldn't find a leak could also just be water pump if I had a compression tester that worked I'd be able to check but unfortunately I don't.
No coolant in the oil tho or oil in the coolant.

Also the header on it has a crack in it looks like some one has had a go at trying to weld it up.

Not sure what it is worth but seein as I only paid just over 1000 for my new one with 160 000ks on it

Ill say $300 neg
Author:  Joe [ Wed Mar 06, 2013 11:18 pm ]
Post subject:  Re: G16a engine for sale possible blown head gasket QLD
Hey mate these blocks are prone to cracking and that could be where the coolant is disappearing from
Have a look at the block under the intake manifold for any signs of coolant weaping out
Author:  Twappett90 [ Wed Mar 20, 2013 11:21 am ]
Post subject:  Re: G16a engine for sale possible blown head gasket QLD
Thanks joe I did end up having a look I put th hose on the inlet and had a look to see if I could see anything seeping out of the block where you said I couldn't see any cracks or anything I had a few small drips emerging from a welch plug in the inlet manifold not sure if that might be new tho? Also found the running rough problem I pulled the ignition leads off the old motor and one of the pretty much fell apart in my hand I'm assuming this would cause the engine not be performing 100%

I ended up selling the engine to a guy for $100 who ended up just wanting the crank shaft.

I am however interested in this block cRacking issue as I still a g16a is this due to over heating / old age?
Author:  Joe [ Wed Mar 20, 2013 6:15 pm ]
Post subject:  Re: G16a engine for sale possible blown head gasket QLD
Pretty sure it's a over heating issue that causes it but i'm not 100% sure on that
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/