well there you go, i figured, being a sierra diff it would have been to small for a vitara... will try & store that one in the memory bank
| auszookers.com https://auszookers.com/forum/ |
|
| (QLD)- rear diff with ARB, rear diff with minispool bits etc https://auszookers.com/forum/viewtopic.php?f=7&t=40888 |
Page 1 of 1 |
| Author: | daisy [ Tue May 14, 2013 4:12 pm ] |
| Post subject: | (QLD)- rear diff with ARB, rear diff with minispool bits etc |
selling two diffs 1 complete with ARB air locker $1000 above has 3.9 centre on NT perches and has NT flange 1 complete with mini spool - $250 above has 3.9 centre on NT perches and has WT flange Jimny alloys - with buggered tyres and 1 new spare - could do with a clean up has paint overspray etc on it- 50 bux the lot (5) vitara dash cluster - suit G16b conversion speedo etc - $25 vitara clutch fan good condition $40 Can freight. |
|
| Author: | dougies_tx5turbo [ Tue May 14, 2013 4:23 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
Pm sent |
|
| Author: | bigrig91 [ Tue May 14, 2013 4:38 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
Do you know if that mini spool works in a vitara rear diff? |
|
| Author: | atari4x4 [ Tue May 14, 2013 4:42 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
bigrig91 wrote: Do you know if that mini spool works in a vitara rear diff? nope, if it's a sierra one, it's same size as a vitara front. |
|
| Author: | Gwagensteve [ Tue May 14, 2013 5:27 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
I think you're wide of the mark there Atari. From experience, the Trail tough mini spool fits either a sierra rear or vitara rear. Mines been in both. Steve. |
|
| Author: | atari4x4 [ Tue May 14, 2013 5:35 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
well there you go, i figured, being a sierra diff it would have been to small for a vitara... will try & store that one in the memory bank
|
|
| Author: | goldpoacher [ Tue May 14, 2013 10:02 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
Shame freight so expensive,would consider the rear air lock diff,in Sydney to far away |
|
| Author: | Nzkarta23 [ Sat Dec 20, 2014 9:03 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
Still got the clutch fan |
|
| Author: | rwt65 [ Sun Dec 21, 2014 4:13 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
|
|
|
| Author: | tanshi [ Sun Dec 21, 2014 5:13 pm ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
Guys this is more than a year old. |
|
| Author: | Nzkarta23 [ Mon Dec 22, 2014 7:54 am ] |
| Post subject: | Re: (QLD)- rear diff with ARB, rear diff with minispool bits |
Oopps I was just searching clutch fan didn't look at date lol |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|