auszookers.com
https://auszookers.com/forum/

Jimny Parts - Flywheel, arms, bushes etc
https://auszookers.com/forum/viewtopic.php?f=7&t=50183		 Page 1 of 1
Author:  Jimny_No_Power [ Mon May 25, 2015 7:33 pm ]
Post subject:  Jimny Parts - Flywheel, arms, bushes etc
I've got few spares, (M13A Jimny).
They're just gathering dust, so thought I'd make them avaliable if anyone is caught short for a part. Prefer to swap some bits, though ill take an offer. All were from road use only.

2 X rear radius arms. Straight. Bushes a bit old but OK.
Flywheel. Used. Surface was in great condition. No heat spots etc. It's been off for 6 weeks so would need a quick clean up.
Clutch plate and case, replaced with an upgrade. Heaps of meat on it, no damage. Free to any poor bugger who has the same maintenance budget I had for years :D

Also got a dozen OEM radius arm bushes in packaging. Both types. 46282-81A00 46213-76J00. I'll update the post when I find more or anything goes.

Cheers,

Joe
Author:  Scrawny [ Mon May 25, 2015 8:19 pm ]
Post subject:  Re: Jimny Parts - Flywheel, arms, bushes etc
All the bits free?
Author:  Jimny_No_Power [ Mon May 25, 2015 11:18 pm ]
Post subject:  Re: Jimny Parts - Flywheel, arms, bushes etc
My post wasn't very clear, I'll edit it in a sec.

Not all free, I'd rather swap a few bits or an offer if someone is looking for a part they need.

The clutch is good, that's free.
The flywheel I should get skimmed to do it by the book, I'll get It done when I get chance.

Tbh, I think Suzuki had around 40 bucks each out of me for the bushes (and the guy was a tool). I'd rather lose a bit on them than send any business their way :D
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/