| auszookers.com https://auszookers.com/forum/ |
|
| Someone who can weld in Perth https://auszookers.com/forum/viewtopic.php?f=8&t=10487 |
Page 1 of 1 |
| Author: | Ben_Sierra [ Wed Mar 17, 2010 3:22 am ] |
| Post subject: | Someone who can weld in Perth |
Ok so I bought a tube bumper on ebay and it appears that it was from a NT not a WT since it mounts on the outside of the chassis rails - exactly where my spring hangars are.... So, i need someone who can cut the mounts off and flip them so it mounts on the inside of the rails... Will pay in beer (or cash if preferred...) |
|
| Author: | gregdixon [ Wed Mar 17, 2010 2:12 pm ] |
| Post subject: | Re: Someone who can weld in Perth |
I can help you out if you want. I am in Cittering though so you might want to see if you can get someone closer. If you have no luck with anyone closer you are more than welcome to come up. |
|
| Author: | Ben_Sierra [ Wed Mar 17, 2010 3:57 pm ] |
| Post subject: | Re: Someone who can weld in Perth |
Thanks mate I'll bear it in mind.... Not keen to drive it too far atm as it has no bumper, indicators, or numberplate on it... |
|
| Author: | MrRocky [ Wed Mar 17, 2010 10:39 pm ] |
| Post subject: | Re: Someone who can weld in Perth |
can weld it in ballajura for ya |
|
| Author: | Ben_Sierra [ Wed Mar 17, 2010 10:50 pm ] |
| Post subject: | Re: Someone who can weld in Perth |
Thats a bit closer.... I might be able to get it up there... I'll have to have a think about how and when..... I might have to swueeze it into the swift and drive it up... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|