[Highway-Star]

Mainly am after a pair or 2 of the factory anti-inversion plates that are attached to these. Want to put them on the front of my Sierra to stop spring inversion.
Only looking for local stuff (Near Ipswich, QLD), and cheap or free, and if I can get them in the next day or 2. Otherwise I'll make something up.

Cheers


PS: sorry if this makes no sense, its 1:30 in the morning...

[steak_knife]

I'm sure you have lot's of steel laying round, just make em..

Or at least that's what Jas tell's me when I want to cut his chassis's up!!

[steak_knife]

P.s. Thay only on rear of w/t's......

[tanshi]

are there any on my spare chassis? if there are you can have them

[BlueSuzy]

Cut a piece of uni strut.

[Highway-Star]

Yeah, might make my own, just hope I don't catch on fire again

I'll go over and have a look Darren, but I thought the green chassis was bare these days.


What do you mean by uni strut Bluesuzy?

[tanshi]

i stole the front hangers and the fixed end of the rear but i thing the rear one is still there. just about ready to throw that chassis out

[Highway-Star]

OK, they are still on the chassis
When your dad gets home tonight, I'll see If I can bust into his shed and nick a power point. Thanks

[steak_knife]

BlueSuzy wrote:

Cut a piece of uni strut.

Is that a sexy walk a uni student does??

[BlueSuzy]

Wow sorry late reply!

http://www.connecttechnologiesinc.com/b ... uni_strut/

Unistrut is a quick fixing system for industrial usages, hanging stuff from walls or roofs etc.. Such as cable trays, piping etc.

I made some new rear hangars for mine, then this was scrap at work, so i got some and cut 1 side out of it, so it looks kinda original. Otherwise you can always weld a plate on the back of the spring hangar. Pretty simple stuff.