auszookers.com
https://auszookers.com/forum/

WTD: front WT diff's
https://auszookers.com/forum/viewtopic.php?f=8&t=16988		 Page 1 of 1
Author:  31zook [ Tue Nov 23, 2010 5:48 am ]
Post subject:  WTD: front WT diff's
i need the housing, axles+CV's, and the steering link that goes from knuckle to knuckle.

i also want another front WT housing, steering link as above + knuckles

thanks :D
Author:  daisy [ Tue Nov 23, 2010 7:33 am ]
Post subject:  Re: WTD: front WT diff's
8) 8) :lol: :lol: 8) 8)
Author:  ck13488 [ Tue Nov 23, 2010 8:09 am ]
Post subject:  Re: WTD: front WT diff's
31zook wrote:
i need the housing, axles+CV's, and the steering link that goes from knuckle to knuckle.

i also want another front WT housing, steering link as above + knuckles

thanks :D

i have the set of complete diffs, front and rear out of the hartop i wrecked that i dont need anymore 8) they are complete and includes steering link
Author:  31zook [ Tue Nov 23, 2010 9:48 am ]
Post subject:  Re: WTD: front WT diff's
ck13488 wrote:
31zook wrote:
i need the housing, axles+CV's, and the steering link that goes from knuckle to knuckle.

i also want another front WT housing, steering link as above + knuckles

thanks :D

i have the set of complete diffs, front and rear out of the hartop i wrecked that i dont need anymore 8) they are complete and includes steering link


i was about to send you a message :lol: hold just the front :D

daisy wrote:
8) 8) :lol: :lol: 8) 8)


you know where this is going 8)
Author:  steak_knife [ Tue Nov 23, 2010 9:50 am ]
Post subject:  Re: WTD: front WT diff's
Twin steer?? :roll:
Author:  Brett [ Tue Nov 23, 2010 5:20 pm ]
Post subject:  Re: WTD: front WT diff's
if this is to do the twin steer run a tape over the chassis and diff 1st.see if it doesn't fit with out hacking up the chassis. the diffs are not wide enough
Author:  31zook [ Wed Nov 24, 2010 4:20 am ]
Post subject:  Re: WTD: front WT diff's
ill sort the chassis out ;)
Author:  31zook [ Thu Nov 25, 2010 5:15 am ]
Post subject:  Re: WTD: front WT diff's
bump :D
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/