I have a whole body and chassy here in melbourne that you can have for $200
Bonnet, b pillar, tailgate all in good nick. Frieght might be a bugger tho!
Dave
| auszookers.com https://auszookers.com/forum/ |
|
| Floor pans https://auszookers.com/forum/viewtopic.php?f=8&t=21886 |
Page 1 of 1 |
| Author: | tonyevans [ Thu May 12, 2011 6:43 am ] |
| Post subject: | Floor pans |
Anyone got a stuffed body they would like to cut out the floor pans for me? I am after both front and rear to make fit in an SJ NT |
|
| Author: | want33s [ Thu May 12, 2011 8:25 am ] |
| Post subject: | Re: Floor pans |
Take a photo with an outline of where you want it cut and I'll see what I have that's suitable. Outline can be done on computer with MS Paint or just plain old masking tape. |
|
| Author: | bohuler [ Thu May 12, 2011 8:58 am ] |
| Post subject: | Re: Floor pans |
I have a whole body and chassy here in melbourne that you can have for $200 Bonnet, b pillar, tailgate all in good nick. Frieght might be a bugger tho!
Dave |
|
| Author: | tonyevans [ Fri May 13, 2011 12:07 am ] |
| Post subject: | Re: Floor pans |
want33s wrote: Take a photo with an outline of where you want it cut and I'll see what I have that's suitable.
Outline can be done on computer with MS Paint or just plain old masking tape. 
2 Front Driver side would be great if you have them - Tony |
|
| Author: | shep [ Fri May 13, 2011 12:23 am ] |
| Post subject: | Re: Floor pans |
for your tray i would cut a bit more out and just weld in some 2mm flat, same with the footwells just make it up with some 2mm. have a look at bails build thread as his came out great. |
|
| Author: | 4wheeljive [ Fri May 13, 2011 12:24 am ] |
| Post subject: | Re: Floor pans |
Would it be easer to get a sheety to knock some thing to match |
|
| Author: | 4wheeljive [ Fri May 13, 2011 12:25 am ] |
| Post subject: | Re: Floor pans |
Lol sheep beat me to it lol |
|
| Author: | tonyevans [ Fri May 13, 2011 12:39 am ] |
| Post subject: | Re: Floor pans |
I can beat my own if need be and the nearest panel beater is about 300ks away - It is just easier and quicker if I can get pans is all. |
|
| Author: | want33s [ Fri May 13, 2011 3:30 am ] |
| Post subject: | Re: Floor pans |
I can supply the RHF and rear sections but no LHF.. |
|
| Author: | tonyevans [ Fri May 13, 2011 4:52 am ] |
| Post subject: | Re: Floor pans |
PM'd |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|