| auszookers.com https://auszookers.com/forum/ |
|
| sill panel https://auszookers.com/forum/viewtopic.php?f=8&t=22356 |
Page 1 of 1 |
| Author: | trity [ Sun May 29, 2011 5:13 am ] |
| Post subject: | sill panel |
hey im looking for something to replace the standard sill panels as the mounts are a bit rusted seen a few running around with chequerplate panels which look quite good? anyone know where i can get them from in Perth or posted to Perth? |
|
| Author: | zooky08 [ Sun May 29, 2011 5:24 am ] |
| Post subject: | Re: sill panel |
Easiest way is to make your own or you can get them from lowrange No point when you can just make them yourself |
|
| Author: | jimbo_jones [ Sun May 29, 2011 5:24 am ] |
| Post subject: | Re: sill panel |
buy some dimond plate and make them your self |
|
| Author: | trity [ Sun May 29, 2011 5:33 am ] |
| Post subject: | Re: sill panel |
how easy is diamond plate to cut? angle grinder? |
|
| Author: | SierraDan [ Sun May 29, 2011 8:06 am ] |
| Post subject: | Re: sill panel |
Its just alloy sheet. so yes a grinder will do fine. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|