| auszookers.com https://auszookers.com/forum/ |
|
| LJ50 Transfer Case https://auszookers.com/forum/viewtopic.php?f=8&t=23571 |
Page 1 of 1 |
| Author: | B1102 [ Mon Jul 04, 2011 8:42 pm ] |
| Post subject: | LJ50 Transfer Case |
Hi All, Need to get a replacement transfer case for a lj50, anyone have one lying around that they are happy to part with for some $$$? |
|
| Author: | Highway-Star [ Mon Jul 04, 2011 8:58 pm ] |
| Post subject: | Re: LJ50 Transfer Case |
I have about 13 spare transfers laying around  
I'm guessing you mean a 3.0:1 case? or are you after a 2.5:1 case? I have both, I'm just not sure if any of the 3.0:1 cases would be much chop without a bearing kit through them. Anyway I'm near Ipswich, if your OK with picking up from down here, I'm happy to sell you one. 
|
|
| Author: | LittleJeep [ Mon Jul 04, 2011 10:01 pm ] |
| Post subject: | Re: LJ50 Transfer Case |
 you got more LJ crap than everyone in QLD put together! i knew you had lots of stuff but i think that's a bit over the top!
|
|
| Author: | 303zuke [ Tue Jul 05, 2011 1:15 am ] |
| Post subject: | Re: LJ50 Transfer Case |
There's also one listed on E-bay atm, but it doesn't specify the ratio. You might need to convince him to post/courier, and maybe drop the price too. |
|
| Author: | Highway-Star [ Tue Jul 05, 2011 2:10 am ] |
| Post subject: | Re: LJ50 Transfer Case |
LittleJeep wrote: you got more LJ crap than everyone in QLD put together! i knew you had lots of stuff but i think that's a bit over the top!That shed is more full since that photo was taken.......
Why do you think I'm happy to sell bits off? I know I have more than we need..... |
|
| Author: | Verm1n [ Tue Jul 05, 2011 5:43 am ] |
| Post subject: | Re: LJ50 Transfer Case |
Highway-Star wrote: LittleJeep wrote: you got more LJ crap than everyone in QLD put together! i knew you had lots of stuff but i think that's a bit over the top!That shed is more full since that photo was taken....... Why do you think I'm happy to sell bits off? I know I have more than we need..... soz highway star.. there is a point in everyones life where u accumulate too much stuff.. soo.. wat im trying to say is.. gimme gimme gimme 
|
|
| Author: | LittleJeep [ Tue Jul 05, 2011 6:25 am ] |
| Post subject: | Re: LJ50 Transfer Case |
^^^the last thing you need is more crap! you just got rid of some of it, you don't need more!^^^ |
|
| Author: | B1102 [ Tue Jul 05, 2011 6:48 am ] |
| Post subject: | Re: LJ50 Transfer Case |
Not so sure on what the ratios mean, which one is best also how much?? Thanks heaps Don't mind the drive to pick up either Cheers |
|
| Author: | Highway-Star [ Tue Jul 05, 2011 10:59 am ] |
| Post subject: | Re: LJ50 Transfer Case |
B1102 wrote: Not so sure on what the ratios mean, which one is best also how much??
Thanks heaps Don't mind the drive to pick up either Cheers There are 2 ratios. One has appropriately 3:1 low range ratio, the other has approximately 2.5:1 low range ratio. Most LJ50's ran the 3:1, though some hardtops were supposed to have the 2.5:1. Most LJ80's ran the 2.5:1 case, though some can be found with the 3:1 case. Which is better depends on the vehicles setup (engine, diffs and tyres) and what yours using it for. If your happy with the vehicle as it is, find what your is by putting it in low range, and counting how many times you have to turn the input to get 1 rotation of he output. It will either be 2.5 or 3. I'll have a look tomorrow and check I have a good one of each type and PM you a price then. |
|
| Author: | B1102 [ Wed Jul 06, 2011 8:05 am ] |
| Post subject: | Re: LJ50 Transfer Case |
Great thanks alot |
|
| Author: | Highway-Star [ Wed Jul 06, 2011 10:09 am ] |
| Post subject: | Re: LJ50 Transfer Case |
PM sent. Sorry I'm a bit late, the Internet was playing up... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|