| auszookers.com https://auszookers.com/forum/ |
|
| wanted reduction gears https://auszookers.com/forum/viewtopic.php?f=8&t=24775 |
Page 1 of 1 |
| Author: | daduke [ Sat Aug 13, 2011 4:40 am ] |
| Post subject: | wanted reduction gears |
wanted reduction geras to suit 1.3 transfer case |
|
| Author: | Shansh [ Sat Aug 13, 2011 8:06 am ] |
| Post subject: | Re: wanted reduction gears |
www.lowrange.com |
|
| Author: | joel [ Sat Aug 13, 2011 8:27 am ] |
| Post subject: | Re: wanted reduction gears |
Shansh wrote: www.lowrange.com
lets try www.lowrangeoffroad.com |
|
| Author: | Shansh [ Sat Aug 13, 2011 8:51 am ] |
| Post subject: | Re: wanted reduction gears |
|
|
|
| Author: | 303zuke [ Sun Aug 14, 2011 11:01 am ] |
| Post subject: | Re: wanted reduction gears |
joel wrote:
Also try Trail Tough |
|
| Author: | daduke [ Mon Aug 15, 2011 9:52 am ] |
| Post subject: | Re: wanted reduction gears |
I can get straight cut 6.5s for $380 new does anyone know how noisy they are when doing daily driving |
|
| Author: | Teracis [ Mon Aug 15, 2011 10:02 am ] |
| Post subject: | Re: wanted reduction gears |
daduke wrote: I can get straight cut 6.5s for $380 new does anyone know how noisy they are when doing daily driving
If they are the same one's that lowrange offroad sell then they should be fine, mine are pretty noisy because I only have one transfer boot and a bare floor in the zook. Anto86's on the other hand is quiet as, even on the highway, but that's in a coily and they are far more soundproof than my zook. |
|
| Author: | daduke [ Mon Aug 15, 2011 10:29 am ] |
| Post subject: | Re: wanted reduction gears |
these ones are out of brissy also one of my mates found them so iam not sure who there through but thanksfor that info cheers |
|
| Author: | Damo [ Mon Aug 15, 2011 12:10 pm ] |
| Post subject: | Re: wanted reduction gears |
daduke wrote: I can get straight cut 6.5s for $380
More details pls. |
|
| Author: | daduke [ Tue Aug 16, 2011 9:29 am ] |
| Post subject: | Re: wanted reduction gears |
what you need to know look up mark adaptions i had a look today they are 5.06.1 ratio |
|
| Author: | Damo [ Tue Aug 16, 2011 10:32 am ] |
| Post subject: | Re: wanted reduction gears |
daduke wrote: what you need to know look up mark adaptions i had a look today they are 5.06.1 ratio
Cheap but noisy they reckon  If their website is anything to go by I think i'll pass 
|
|
| Author: | daduke [ Tue Aug 16, 2011 12:23 pm ] |
| Post subject: | Re: wanted reduction gears |
yeah bit dodgy i will give them a call and see what they say about them |
|
| Author: | jonno_racing [ Tue Aug 16, 2011 12:48 pm ] |
| Post subject: | Re: wanted reduction gears |
yeah i wouldnt be keen. just go 6.5s |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|