| auszookers.com https://auszookers.com/forum/ |
|
| vitara a arm spacer? https://auszookers.com/forum/viewtopic.php?f=8&t=27048 |
Page 1 of 1 |
| Author: | Brett [ Sun Oct 23, 2011 8:16 am ] |
| Post subject: | vitara a arm spacer? |
i know its a long shot but does anyone have a a arm spacer for a vitara? its the bit that that bolt to the top of the diff and spacers up the ball joint |
|
| Author: | Timbo_ [ Sun Oct 23, 2011 9:17 am ] |
| Post subject: | Re: vitara a arm spacer? |
more detail in the part you are looking for? |
|
| Author: | Brett [ Sun Oct 23, 2011 9:34 am ] |
| Post subject: | Re: vitara a arm spacer? |
Dont know how to explain it more. its just to space up the a arm ball joint on the rear diff. low range sells them but postage would be close to the cost of it |
|
| Author: | christover1 [ Sun Oct 23, 2011 10:26 am ] |
| Post subject: | Re: vitara a arm spacer? |
I bought mine from Bits4Vits in UK. Wasn't real cheap, but not something I could make myself http://www.bits4vits.co.uk/store/vitara ... od_42.html you can get a postage quote on web site, without committing. Turn off tax, as overseas dont have to pay it, and switch it to Aus currency. I'm fairly certain someone is wrecking a lifted vit for a Sierra conversion. |
|
| Author: | christover1 [ Sun Oct 23, 2011 10:27 am ] |
| Post subject: | Re: vitara a arm spacer? |
http://www.bits4vits.co.uk/store/vitara ... od_42.html |
|
| Author: | christover1 [ Sun Oct 23, 2011 10:29 am ] |
| Post subject: | Re: vitara a arm spacer? |
|
|
|
| Author: | Mick70b [ Tue Oct 25, 2011 5:42 am ] |
| Post subject: | Re: vitara a arm spacer? |
I haven't added one to my Vit yet, but that one looks a LOT stronger than the cast ones that are avaiable elsewhere! |
|
| Author: | christover1 [ Tue Oct 25, 2011 5:49 am ] |
| Post subject: | Re: vitara a arm spacer? |
Mick70b wrote: I haven't added one to my Vit yet, but that one looks a LOT stronger than the cast ones that are avaiable elsewhere!
The comment from the site " ONE PIECE construction, no welds on this, it's been CNC machined out of one block of steel, and then powdercoated. " was the deciding factor for me. |
|
| Author: | tombutt [ Tue Oct 25, 2011 10:19 am ] |
| Post subject: | Re: vitara a arm spacer? |
id personally be looking to upgrade away from the ball joint set up as i have done in my car as they dont last very long when treated badly |
|
| Author: | Brett [ Tue Oct 25, 2011 5:26 pm ] |
| Post subject: | Re: vitara a arm spacer? |
i have been looking at the altered ego long are kit but do have the coin, might have to just say up. am after a spacer for now because the a arm is limiting the back end |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|