| auszookers.com https://auszookers.com/forum/ |
|
| BRISBANE: 1.3 transfer case https://auszookers.com/forum/viewtopic.php?f=8&t=28155 |
Page 1 of 1 |
| Author: | scorpydude [ Tue Nov 29, 2011 7:57 pm ] |
| Post subject: | BRISBANE: 1.3 transfer case |
looking for a 1.3L Sierra transfer case pref local to Brisbane (More info: the hex bolt, drain plugs and speedo cable cylinder must be able to be removed but the bearings and seals can be in any condition) |
|
| Author: | Bruce [ Tue Nov 29, 2011 8:56 pm ] |
| Post subject: | Re: BRISBANE: 1.3 transfer case |
So my offer of, "if you fuck up with what you have there, that I have spare parts sitting at home that you are welcome to," is not valid to you? Righto then. |
|
| Author: | scorpydude [ Tue Nov 29, 2011 9:02 pm ] |
| Post subject: | Re: BRISBANE: 1.3 transfer case |
thought you meant the smaller stuff hex bolt and the speedo chamber cylinder, not the whole case Bruce? I can't get the speedo chamber and the hex bolt out of the case I have. So I can't replace those parts, looks like I'll need to find another case. |
|
| Author: | Bruce [ Tue Nov 29, 2011 9:21 pm ] |
| Post subject: | Re: BRISBANE: 1.3 transfer case |
As I said, I have lots of spare parts for cases. Might even have a empty case. I'll look for you. |
|
| Author: | Damo [ Tue Nov 29, 2011 9:52 pm ] |
| Post subject: | Re: BRISBANE: 1.3 transfer case |
I have a case that I could probably rat for parts. I think i'm a bit closer, im at Murarrie. You can drop around with yours sometime and we'll take a look at it if you like. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|