| auszookers.com https://auszookers.com/forum/ |
|
| old brake drum/ disc: perth north of river https://auszookers.com/forum/viewtopic.php?f=8&t=29289 |
Page 1 of 1 |
| Author: | missmyljdaze [ Thu Jan 05, 2012 8:01 am ] |
| Post subject: | old brake drum/ disc: perth north of river |
Gidday fellas, I am needing an old brake disc or brake drum with a 5 x 5.5 stud pattern to make a special tool to help pull the hubs out of an old jeep. 
Anyone have some dead bits they want to throw out? northen suburbs of perth preferably- but I dont mind trekking South if I have to 
Thanks, stephen. |
|
| Author: | MrRocky [ Thu Jan 05, 2012 8:27 am ] |
| Post subject: | Re: old brake drum/ disc: perth north of river |
have a zuk rear wheel holder ? yours if it suits |
|
| Author: | madmacca [ Thu Jan 05, 2012 8:51 am ] |
| Post subject: | Re: old brake drum/ disc: perth north of river |
I have a couple of old sierra disks you can have , but im in Lesmurdie 
|
|
| Author: | missmyljdaze [ Thu Jan 05, 2012 8:57 am ] |
| Post subject: | Re: old brake drum/ disc: perth north of river |
The old jeep hubs are pretty well stuck to the axles (tapered axle shaft with keyway that the hub is tightened on with 567595ft/lbs tension. I was going to belt the bejeezus out of the drums to loosen the hub while winding up the wheel puller. But..... I have been advised to be gentle to the relatively fragile and ancient jeep drums and pull directly on the wheelnuts- so I figured if I bolt on an old knackered suzuki disk or drum to the hub, using the wheelnuts- it gives me something to hook the wheel puller onto without wrecking the original drums. An old disc is probably the easiest option, but a drum would work too. Stephen. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|