| auszookers.com https://auszookers.com/forum/ |
|
| G13BA engine in NSW for rebuild https://auszookers.com/forum/viewtopic.php?f=8&t=31510 |
Page 1 of 1 |
| Author: | buglemcdougle [ Wed Mar 28, 2012 1:31 pm ] |
| Post subject: | G13BA engine in NSW for rebuild |
I'm looking for a G13BA for my recently purchased zook. I want to rebuild another motor so i spend as little time as possible off the road & as much time as possible 'off road'  Everything seems to be in QLD, hoping for something in NSW close to Sydney. |
|
| Author: | matty_wall [ Wed Mar 28, 2012 4:04 pm ] |
| Post subject: | Re: G13BA engine in NSW for rebuild |
I may have one in the next few weeks. Burns oil like no tomorrow, rings and valve seals are fuggered. where are you located? |
|
| Author: | zooktastic [ Wed Mar 28, 2012 4:12 pm ] |
| Post subject: | Re: G13BA engine in NSW for rebuild |
i have one ready to go near penrith. ran well from what i was told. ill throw in another semi complete one for spares. |
|
| Author: | buglemcdougle [ Wed Mar 28, 2012 7:55 pm ] |
| Post subject: | Re: G13BA engine in NSW for rebuild |
matty_wall wrote: I may have one in the next few weeks. Burns oil like no tomorrow, rings and valve seals are fuggered. where are you located? I'm just near Nowra NSW. zooktastic wrote: i have one ready to go near penrith. ran well from what i was told. ill throw in another semi complete one for spares. What sort of money are you looking for? And what yr model is the good one? |
|
| Author: | mazdaspater [ Mon Apr 02, 2012 8:11 pm ] |
| Post subject: | Re: G13BA engine in NSW for rebuild |
Got one in Canberra. May be able to get it down that way. From a swift. Was told it had less than 130K on it but I dont think it had an oil change in that time. Comes with a five speed with noisy input shaft bearing. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|