| auszookers.com https://auszookers.com/forum/ |
|
| lj50 3cyl head https://auszookers.com/forum/viewtopic.php?f=8&t=32495 |
Page 1 of 1 |
| Author: | thorno [ Thu May 10, 2012 8:24 pm ] |
| Post subject: | lj50 3cyl head |
hi all, any one got a lj50 3 cylinder block/barrell in good condition, prefer std bore size if possible, mine had a seized head bolt that broke off in the head the guy i gave it to too fix fucked it !!! help please! the head bolt hole has been over sized by drilling the left over bolt out, can this be fixed?  thx mark
|
|
| Author: | zookfun [ Thu May 10, 2012 10:01 pm ] |
| Post subject: | Re: lj50 3cyl head |
Ive got a whole load of lj50 parts, I think a saw a few heads in there.. Where abouts are you? Id probably just go a helicoil though- stronger than the alloy its screwed into |
|
| Author: | Boggomobile [ Fri May 11, 2012 7:48 am ] |
| Post subject: | Re: lj50 3cyl head |
Hi Mark, Not sure if you want a barrell (the part that gets rebored) or the head (not rebored), if it is the latter, then I have a spare head. The early models have very little clearance between head bolts and holes, they can seize in the aluminium, broken them myself. The later models have more clearance and pretty much always come undone. Cheers Greg 0428 789854 |
|
| Author: | zook1987 [ Sat May 12, 2012 12:43 pm ] |
| Post subject: | Re: lj50 3cyl head |
hey zookfun do you have a set of rearview mirrors that you'd like to sell? |
|
| Author: | tanshi [ Mon May 14, 2012 1:51 pm ] |
| Post subject: | Re: lj50 3cyl head |
thorno wrote: hi all, any one got a lj50 3 cylinder block/barrell in good condition, prefer std bore size if possible, mine had a seized head bolt that broke off in the head the guy i gave it to too fix fucked it !!! help please! the head bolt hole has been over sized by drilling the left over bolt out, can this be fixed? thx markwhere are you located mate? i have a few |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|