| auszookers.com https://auszookers.com/forum/ |
|
| 5.12 Centres front and rear for vitara and steel GV diff https://auszookers.com/forum/viewtopic.php?f=8&t=33417 |
Page 1 of 1 |
| Author: | bigrig91 [ Thu Jun 14, 2012 8:44 pm ] |
| Post subject: | 5.12 Centres front and rear for vitara and steel GV diff |
Chasing some 5.12 centres and a steel front diff to put into my vitara. Preferably in qld but will ship if right price. Contact me here or on 0413244035. Cheers |
|
| Author: | bohuler [ Fri Jun 15, 2012 7:24 pm ] |
| Post subject: | Re: 5.12 Centres front and rear for vitara and steel GV diff |
 Good luck mate, i've been looking for 4 months now. I was quoted around the $800 about 4 weeks ago, and that was just for the front diff and housing (I already has the 5:12's) which i recon is far to much. I was looking to buy a stat write off GV cause it was going to be easier but i've put the whole lot in the too expensive basket atm unless one pops up at the right price.Dave |
|
| Author: | tonka_tuff [ Fri Jun 15, 2012 7:46 pm ] |
| Post subject: | Re: 5.12 Centres front and rear for vitara and steel GV diff |
i have a 5:12 crownwheel and pinion gear here but the carrier is farrked.. |
|
| Author: | shep [ Fri Jun 15, 2012 8:52 pm ] |
| Post subject: | Re: 5.12 Centres front and rear for vitara and steel GV diff |
i thought they would be every where. i have 2 sets of diffs, probably a bit far to post however |
|
| Author: | christover1 [ Sat Jun 16, 2012 8:33 am ] |
| Post subject: | Re: 5.12 Centres front and rear for vitara and steel GV diff |
My GV steel front diff was sent from Maroochydore in Qld to Victoria, delivery charge was only $80. So don't rule out buying from interstate. It was complete with diff centre and inner axle. A good cheaper option is this http://www.srcustoms.ca/index.php?optio ... &Itemid=56 
|
|
| Author: | bigrig91 [ Sat Jun 16, 2012 12:54 pm ] |
| Post subject: | Re: 5.12 Centres front and rear for vitara and steel GV diff |
Cheers for all the input guys but im goin to sink my teeth into the 2.5l conversion first. Water pump just shit itself and its basically a front of the motor off job. |
|
| Author: | Built4thrashing [ Sun Jun 17, 2012 7:09 pm ] |
| Post subject: | Re: 5.12 Centres front and rear for vitara and steel GV diff |
christover1 wrote: That would be an awsome mod if it fit without having to grind off the old mount. If it could be made to bolt onto a unbroken diff it would be a better solution. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|