| auszookers.com https://auszookers.com/forum/ |
|
| delete https://auszookers.com/forum/viewtopic.php?f=8&t=33918 |
Page 1 of 1 |
| Author: | shlonga86 [ Fri Jul 06, 2012 3:38 pm ] |
| Post subject: | delete |
Good day Gents, I'm chasing a cheap front bar to fit a coily. nothing fancy, i just need to for a road worthy (and until I can afford a TSOR bull bar haha). I've tried a stock front bumper but it doesn't fit properly (its a bit bent), I'm going to try and make it fit but i would prefer a proper bull bar. Any help would be appreciated. - Scott |
|
| Author: | Fatzook [ Fri Jul 06, 2012 4:58 pm ] |
| Post subject: | Re: [Nth Bris] any (cheap) front bar to fit a coily |
Have you tried a stock coily bar? ( plastic one) it should fit. |
|
| Author: | shlonga86 [ Fri Jul 06, 2012 7:47 pm ] |
| Post subject: | Re: [Nth Bris] any (cheap) front bar to fit a coily |
Yeah, the one I have doesn't quite fit properly. I was planning to just bash it until it sits properly then tek screw it on haha. But if I could find something I can bolt to the chassis, it would be better. |
|
| Author: | rwt65 [ Sat Jul 07, 2012 6:23 pm ] |
| Post subject: | Re: [Nth Bris] any (cheap) front bar to fit a coily |
Is a decent alloy bullbar to suit a coiler on ebay, is located on the goldcoast. It has no mounts/brackets, just the bar. Could be worth keeping an eye on. |
|
| Author: | shlonga86 [ Sat Jul 07, 2012 10:20 pm ] |
| Post subject: | Re: [Nth Bris] any (cheap) front bar to fit a coily |
Ooh! I'll check it out. Cheers! |
|
| Author: | shlonga86 [ Sun Jul 08, 2012 11:59 am ] |
| Post subject: | Re: [Nth Bris] any (cheap) front bar to fit a coily |
Sorted! Please delete |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|