| auszookers.com https://auszookers.com/forum/ |
|
| Transfer case bearings locally https://auszookers.com/forum/viewtopic.php?f=8&t=34834 |
Page 1 of 1 |
| Author: | bob9909 [ Thu Aug 09, 2012 5:03 pm ] |
| Post subject: | Transfer case bearings locally |
Hey just wanted to quickly ask if anyone could tell me where I could order a couple of new bearings from, for my transfer case, I've seen a few full kits, but I only want these two bearings. Would it be worth asking at repco?  Does anyone know anyone that can supply these? I suppose low range probably can, but I would prefer somewhere locally (don't really want to have to wait too long or pay a lot for shipping for a couple of small items) Thanks in advance guys  Cheers |
|
| Author: | Bruce [ Thu Aug 09, 2012 5:18 pm ] |
| Post subject: | Re: Transfer case bearings locally |
Try your local CBC shop. |
|
| Author: | Ridge [ Thu Aug 09, 2012 5:23 pm ] |
| Post subject: | Re: Transfer case bearings locally |
Repco could probably get them but they will be pretty expensive. Go to a bearing shop with the part numbers / samples. |
|
| Author: | Goldnomad [ Fri Aug 10, 2012 6:44 am ] |
| Post subject: | Re: Transfer case bearings locally |
Ask Weaves. He can help |
|
| Author: | Scales [ Fri Aug 10, 2012 7:11 am ] |
| Post subject: | Re: Transfer case bearings locally |
try shooting a message to the guy that sells the whole kit on ebay. 4wd_products or whatever his username is. Sure he could seperate one from a kit and sell it to you, Ive bought heaps of stuff from him You may need to give him the ID, OD and thickness to help him out identifying it |
|
| Author: | bob9909 [ Fri Aug 10, 2012 10:00 am ] |
| Post subject: | Re: Transfer case bearings locally |
Thanks guys, really appreciate the help My suzi has been sitting on ramps for way too long as I procrastinate about one thing or another, really keen to get it up and running again! Cheers |
|
| Author: | Fatzook [ Fri Aug 10, 2012 12:21 pm ] |
| Post subject: | Re: Transfer case bearings locally |
Have you got the old bearings? If so, just go into ANY bearing shop, and get them sized up. There is NOTHING special about those bearings at all, so they will be off the shelf items. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|