| auszookers.com https://auszookers.com/forum/ |
|
| 1.6l Vitara front brake Dust cover/ stoneguard plates https://auszookers.com/forum/viewtopic.php?f=8&t=39623 |
Page 1 of 1 |
| Author: | Santos [ Sat Mar 16, 2013 6:06 pm ] |
| Post subject: | 1.6l Vitara front brake Dust cover/ stoneguard plates |
1.6l Vitara front brake dust cover stoneguard plates the plate that sits behind the rotor. SWB or LWB |
|
| Author: | Santos [ Fri Mar 22, 2013 4:34 pm ] |
| Post subject: | Re: 1.6l Vitara front brake Dust cover/ stoneguard plates |
Bumpy |
|
| Author: | Gwagensteve [ Fri Mar 22, 2013 5:56 pm ] |
| Post subject: | Re: 1.6l Vitara front brake Dust cover/ stoneguard plates |
Are you putting them on a sierra? If so, the spindle bolt pattern is different, as is the rotor location relative to the bolt pattern of the spindle, they 100% won't fit a sierra. Steve |
|
| Author: | Santos [ Fri Mar 22, 2013 9:13 pm ] |
| Post subject: | Re: 1.6l Vitara front brake Dust cover/ stoneguard plates |
Gwagensteve wrote: Are you putting them on a sierra? If so, the spindle bolt pattern is different, as is the rotor location relative to the bolt pattern of the spindle, they 100% won't fit a sierra. Steve i was planing on redrilling new bolt holes. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|