| auszookers.com https://auszookers.com/forum/ |
|
| Lend of a tap Sunshine Coast. https://auszookers.com/forum/viewtopic.php?f=8&t=40087 |
Page 1 of 1 |
| Author: | ozzycouch [ Sat Apr 06, 2013 3:14 pm ] |
| Post subject: | Lend of a tap Sunshine Coast. |
Fitting an air locker and cannot find anywhere a tap to thread the diff houseing. Anyone got on I can borrow for a few hours? Cheers Chris |
|
| Author: | Reubs [ Sat Apr 06, 2013 5:50 pm ] |
| Post subject: | Re: Lend of a tap Sunshine Coast. |
ozzycouch wrote: Fitting an air locker and cannot find anywhere a tap to thread the diff houseing. Anyone got on I can borrow for a few hours? If you want to drive down to Brisbane i've got a 1/8BSP28 tap here you can borrow for the afternoon. I believe you know where I live and you still have my number... otherwise shoot though a PM. |
|
| Author: | mrw82 [ Sat Apr 06, 2013 6:14 pm ] |
| Post subject: | Re: Lend of a tap Sunshine Coast. |
The thread through the diff housing is 1/4"bsp. Not 1/8"bsp. If reubs (or anyone closer) can't help you out I have one here in deception bay. Bring your diff down and we'll tap it out. |
|
| Author: | ozzycouch [ Sat Apr 06, 2013 9:55 pm ] |
| Post subject: | Re: Lend of a tap Sunshine Coast. |
Thanks for the offers guys but the one im threading is around 1/2 inch... |
|
| Author: | mrw82 [ Sat Apr 06, 2013 10:13 pm ] |
| Post subject: | Re: Lend of a tap Sunshine Coast. |
It will measure at around 1/2" outside diameter, but pipe threads (bsp) are measured by the nominal bore of the pipe (or fitting) and is actually 1/4"bsp. That is assuming you are using a typical ARB bulkhead fitting. If you do in fact need a 1/2"bsp tap I can check in the morning and see if I have one. |
|
| Author: | ozzycouch [ Sun Apr 07, 2013 1:13 am ] |
| Post subject: | Re: Lend of a tap Sunshine Coast. |
mrw82 wrote: It will measure at around 1/2" outside diameter, but pipe threads (bsp) are measured by the nominal bore of the pipe (or fitting) and is actually 1/4"bsp. That is assuming you are using a typical ARB bulkhead fitting. If you do in fact need a 1/2"bsp tap I can check in the morning and see if I have one. That sounds like what I need then... Pm sent 
|
|
| Author: | ozzycouch [ Mon Apr 08, 2013 11:07 am ] |
| Post subject: | Re: Lend of a tap Sunshine Coast. |
All sorted. Thanks guys 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|