| auszookers.com https://auszookers.com/forum/ |
|
| LHSGV Rear axle bris https://auszookers.com/forum/viewtopic.php?f=8&t=43623 |
Page 1 of 1 |
| Author: | klutched [ Mon Oct 28, 2013 7:52 pm ] |
| Post subject: | LHSGV Rear axle bris |
Chasing a LHS GV rear axle in Bris, believe both sides are the same. Cheers |
|
| Author: | atari4x4 [ Mon Oct 28, 2013 7:55 pm ] |
| Post subject: | Re: GV Rear axle bris |
bearing removal gone bad? FYI they're different on vitara's, so i'm guessing the GV will have a left & right axle also. |
|
| Author: | klutched [ Mon Oct 28, 2013 8:23 pm ] |
| Post subject: | Re: GV Rear axle bris |
atari4x4 wrote: bearing removal gone bad? FYI they're different on vitara's, so i'm guessing the GV will have a left & right axle also. Nah, that was all good. But the plate where the wheel studs go in looks a bit bent. Will find out for sure tomorrow though if it will wobble like crazy or not. If it's not noticeable I'll leave it. Oh really? Thought they'd be the same because of the diff is centered? |
|
| Author: | Built4thrashing [ Wed Oct 30, 2013 8:05 pm ] |
| Post subject: | Re: GV Rear axle bris |
klutched wrote: atari4x4 wrote: bearing removal gone bad? FYI they're different on vitara's, so i'm guessing the GV will have a left & right axle also. Nah, that was all good. But the plate where the wheel studs go in looks a bit bent. Will find out for sure tomorrow though if it will wobble like crazy or not. If it's not noticeable I'll leave it. Oh really? Thought they'd be the same because of the diff is centered? They are different. One side is about an inch longer. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|