| auszookers.com https://auszookers.com/forum/ |
|
| [QLD - WTD/EOI] LWB Chassis & Cab https://auszookers.com/forum/viewtopic.php?f=8&t=48460 |
Page 1 of 1 |
| Author: | 5ierra [ Mon Nov 17, 2014 12:09 pm ] |
| Post subject: | [QLD - WTD/EOI] LWB Chassis & Cab |
Wonderng if there are any LWB chassis' and Cabs floating around atm? Contemplating a new project and want to see whats available. Would also consider SWB chassis & hardtop. Prefferences: Dont want rust Don't want soft tops. must be NT Must have the 1.3L mounts Bare chassis and cab is fine. Cheers, 5ierra. |
|
| Author: | HAYD0S [ Mon Nov 17, 2014 1:39 pm ] |
| Post subject: | Re: [QLD - WTD/EOI] LWB Chassis & Cab |
Slowsierra is about to chuck a LWB chassis. Check For Sale section |
|
| Author: | slowsierra [ Mon Nov 17, 2014 3:43 pm ] |
| Post subject: | Re: [QLD - WTD/EOI] LWB Chassis & Cab |
I may have what you are after. Pm me |
|
| Author: | Zook_Fan [ Wed Nov 19, 2014 6:49 am ] |
| Post subject: | Re: [QLD - WTD/EOI] LWB Chassis & Cab |
I've got a cab in good condition. I won't say no rust but it's the best I've ever seen. It's sitting on a modified 1.3 chassis, otherwise I also have a standard 1L chassis. |
|
| Author: | 5ierra [ Wed Nov 19, 2014 8:01 am ] |
| Post subject: | Re: [QLD - WTD/EOI] LWB Chassis & Cab |
Where abouts is the rust and how is the chassis modified? Cheers. |
|
| Author: | Zook_Fan [ Wed Nov 19, 2014 9:08 am ] |
| Post subject: | Re: [QLD - WTD/EOI] LWB Chassis & Cab |
Mounts for a CA18de are on there, the rear has an a frame coil conversion and the front is SPOA with a z link. There are two small holes near the a pillar that was for a snorkel I think, there is a small amount of rust spreading from them. If you pm me a mobile number I'll send you some pics of the cab. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|