| Author |
Message |
Polar_Bear
Joined: Sat Aug 12, 2006 11:30 pm Posts: 2511 Location: Adelaide SA
|
 Posted: Sun Jun 06, 2010 2:24 pm |
|
Red_October wrote: DarkHorse wrote: Do you reckon the demister on the rear window is intact? Mine only works 2-3 strips up from the bottom. Really don't want to drive all the way back down there, but maybe...  No idea if it works sorry. I forgot to test it before pulling everything to bits... I'd like to keep the rear door in one piece and sell it whole but if it doesn't sell on ebay then i'll consider selling the glass.
if you end up parting out the back door, i'm after the inside plastic trim panel
will you separate the jesus handle off the dash?
how good are the door / window rubbers?
the big rubber that goes from the bottom of the windscreen, up and over the roof, to the back door, how hard are they to get on and off?
how good are the free wheeling hubs?
_________________ Go Hard, Trailer Home
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Mon Jun 07, 2010 9:11 am |
|
Polar_Bear wrote: Red_October wrote: DarkHorse wrote: Do you reckon the demister on the rear window is intact? Mine only works 2-3 strips up from the bottom. Really don't want to drive all the way back down there, but maybe...  No idea if it works sorry. I forgot to test it before pulling everything to bits... I'd like to keep the rear door in one piece and sell it whole but if it doesn't sell on ebay then i'll consider selling the glass. if you end up parting out the back door, i'm after the inside plastic trim panel  will you separate the jesus handle off the dash? how good are the door / window rubbers? the big rubber that goes from the bottom of the windscreen, up and over the roof, to the back door, how hard are they to get on and off? how good are the free wheeling hubs? I'm willing to part out the door given there has been no interest in the door itself. Quote: if you end up parting out the back door, i'm after the inside plastic trim panel  Done. Quote: Will you separate the jesus handle off the dash? Didn't have one. Quote: how good are the door / window rubbers? Soft and squishy. A little dirty though. Quote: The big rubber that goes from the bottom of the windscreen, up and over the roof, to the back door, how hard are they to get on and off? Have got both of these, they just peel of like all the other rubbers. How good are the free wheeling hubs?[/quote]
Hubs seem to be in good nick. Could probably do with a clean. They turn fine and click into place.
PM me if interested. The car will be going to the wreckers before Friday.
Cheers,
Jimmy 
|
|
|
|
 |
Polar_Bear
Joined: Sat Aug 12, 2006 11:30 pm Posts: 2511 Location: Adelaide SA
|
 Posted: Mon Jun 07, 2010 12:58 pm |
|
Red_October wrote: Polar_Bear wrote: Will you separate the jesus handle off the dash? Didn't have one.
did the dash look like this?
ok i'll take door rubbers, the big rubber that goes over the roof (drivers side mainly) free wheeling hubs, and back door plastic trim 
_________________ Go Hard, Trailer Home
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Mon Jun 07, 2010 8:38 pm |
|
Polar_Bear wrote: Red_October wrote: Polar_Bear wrote: Will you separate the jesus handle off the dash? Didn't have one. did the dash look like this?  ok i'll take door rubbers, the big rubber that goes over the roof (drivers side mainly) free wheeling hubs, and back door plastic trim 
Yep, that's what the dash looks like. Where's the jesus handle?
Edit: Wait, are you referring to the hand brake? 
|
|
|
|
 |
Polar_Bear
Joined: Sat Aug 12, 2006 11:30 pm Posts: 2511 Location: Adelaide SA
|
 Posted: Tue Jun 08, 2010 1:16 pm |
|
Red_October wrote: Yep, that's what the dash looks like. Where's the jesus handle?
the passengers side crash pad/ handle thing above the glove box that unbolts from behind the dash.
how sun damaged are the window rubbers, the part that sits outside ontop of the doors, you know the bit that gets flattened down when you have the window right down and your arm hanging out 
_________________ Go Hard, Trailer Home
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Tue Jun 08, 2010 8:56 pm |
|
|
oh that thing! Yep, I've got that. I'll pull it off this arvo.
The window rubber that sit on the outside/top of door/arm hanging out are pretty bad. They're flaking and are rather squashed.
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Wed Jun 09, 2010 6:25 am |
|
|
|
 |
Polar_Bear
Joined: Sat Aug 12, 2006 11:30 pm Posts: 2511 Location: Adelaide SA
|
 Posted: Wed Jun 09, 2010 12:37 pm |
|
your window rubbers sound as bad as mine  might keep looking on those ones, but if the door rubbers are good i'll take them 
_________________ Go Hard, Trailer Home
|
|
|
|
 |
BlueSuzy

az supporter
Joined: Sun May 04, 2008 11:30 pm Posts: 9711 Location: NSW
Vehicle: SJ51 LWB, SJ70 SWB
|
 Posted: Wed Jun 09, 2010 1:30 pm |
|
|
pm'd
_________________ BlueSuzy wrote: I'm over the G16b's.
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Thu Jun 10, 2010 9:55 am |
|
Polar_Bear wrote: your window rubbers sound as bad as mine  might keep looking on those ones, but if the door rubbers are good i'll take them 
The door seals feel soft and squishy. I'll give them a clean tomorrow and see if I can see signs of cracking etc. The look alright though.
Shoot me a PM with an offer for all the bits you want, and if you wanted them couriered.
So far i've got you down for:
door rubbers (to be ocnfirmed tomorrow)
rubber that goes over the roof (drivers side mainly)
free wheeling hubs
back door plastic trim
jesus handle (crash pad)
|
|
|
|
 |
Polar_Bear
Joined: Sat Aug 12, 2006 11:30 pm Posts: 2511 Location: Adelaide SA
|
 Posted: Thu Jun 10, 2010 1:33 pm |
|
Red_October wrote: Polar_Bear wrote: your window rubbers sound as bad as mine  might keep looking on those ones, but if the door rubbers are good i'll take them  The door seals feel soft and squishy. I'll give them a clean tomorrow and see if I can see signs of cracking etc. The look alright though. Shoot me a PM with an offer for all the bits you want, and if you wanted them couriered. So far i've got you down for: door rubbers (to be ocnfirmed tomorrow) rubber that goes over the roof (drivers side mainly) free wheeling hubs back door plastic trim jesus handle (crash pad)
sounds good, how about a vitara badge off the drivers door? can you get that off without breaking it?
did ya centre console end up selling?
_________________ Go Hard, Trailer Home
|
|
|
|
 |
92vit
Joined: Sun Apr 04, 2010 11:30 pm Posts: 3 Location: canberra
|
 Posted: Thu Jun 10, 2010 11:38 pm |
|
|
Hi jimmy my name is mike and i'm very interested in the estate and i also live in the act do you have a phone number i can contact you on or can you call me on 0447698823
|
|
|
|
 |
hegs218
Joined: Sat Apr 17, 2010 11:30 pm Posts: 33 Location: melbourne
|
 Posted: Fri Jun 11, 2010 12:53 am |
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Fri Jun 11, 2010 7:13 am |
|
Polar_Bear wrote: Red_October wrote: Polar_Bear wrote: your window rubbers sound as bad as mine  might keep looking on those ones, but if the door rubbers are good i'll take them  The door seals feel soft and squishy. I'll give them a clean tomorrow and see if I can see signs of cracking etc. The look alright though. Shoot me a PM with an offer for all the bits you want, and if you wanted them couriered. So far i've got you down for: door rubbers (to be ocnfirmed tomorrow) rubber that goes over the roof (drivers side mainly) free wheeling hubs back door plastic trim jesus handle (crash pad) sounds good, how about a vitara badge off the drivers door? can you get that off without breaking it? did ya centre console end up selling?
I can give it a shot. It's free + postage if I can.
Centre console has been sold.
|
|
|
|
 |
Chop

az supporter
Joined: Sat Aug 12, 2006 11:30 pm Posts: 6456 Location: Radelaide ofcourse!
Vehicle: Suzuki GV 03/ 2010 DDIS NGV
|
 Posted: Tue Jun 15, 2010 8:35 am |
|
Just want to let everyone know, that Red_october is great to deal with!
I bought the fuel lid opener off ebay from him, recieved promptly
Thanks
Chop
_________________ Chop
Suzuki's are like Mogwai's, they multiply!
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Tue Jun 15, 2010 9:30 am |
|
No problemo 
|
|
|
|
 |
BCNYA
Joined: Sun Jun 13, 2010 8:47 am Posts: 7 Location: Newcastle
|
 Posted: Mon Jun 21, 2010 11:12 am |
|
|
Hey mate have u still got the front diff? Does it include axles?
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Mon Jun 21, 2010 11:13 am |
|
|
Still have front diff. No axles.
|
|
|
|
 |
RIKSTR

az supporter
Joined: Sun Apr 26, 2009 11:30 pm Posts: 1278 Location: Canberra
|
 Posted: Wed Jun 23, 2010 3:09 am |
|
Whats left of this rig? Looking for something to comp  but don't need any of that comfy sissy stuff 
|
|
|
|
 |
Red_October

az supporter
Joined: Fri Oct 02, 2009 11:30 pm Posts: 284 Location: ACT
|
 Posted: Wed Jun 23, 2010 6:23 am |
|
|
Front diff including centre is the only thing left. It's alloy though.
|
|
|
|
 |
|