| Author |
Message |
brockysvl
Joined: Wed Jul 20, 2011 9:21 am Posts: 5 Location: Sydney
|
 Posted: Sun Jul 24, 2011 6:21 am |
|
|
Has any one ever popped a coil out of the rear of a sierra. Its got 2 inch lift 2 inch body lift 31s. The coils could be shagged, bumped stops never been adjusted but who wants to do that. I think its got the 40mm ebay kit. Can i put different 50mm extended springs in the rear or alternative springs altogether.
Any help appreciated
|
|
|
|
 |
SierraDan

az supporter
Joined: Fri Feb 04, 2011 10:55 pm Posts: 9348 Location: Newcastle
Vehicle: G13BB Jimny
|
 Posted: Sun Jul 24, 2011 6:50 am |
|
|
I saw that video I think.
Did it only happen once?
_________________ mlm
|
|
|
|
 |
brockysvl
Joined: Wed Jul 20, 2011 9:21 am Posts: 5 Location: Sydney
|
 Posted: Sun Jul 24, 2011 7:45 am |
|
|
yeah it was pushed out going through a water crossing. flexed up and water pressure pushed it out. then my mates hilux drove over it. when you flex it up fully it doesn't seem that tight. I've heard about relocation cones and adjusting bump stops. trying to work out if my coils are shagged or my setup is wrong
|
|
|
|
 |
SierraDan

az supporter
Joined: Fri Feb 04, 2011 10:55 pm Posts: 9348 Location: Newcastle
Vehicle: G13BB Jimny
|
 Posted: Sun Jul 24, 2011 7:48 am |
|
|
You might have some sagged springs, or whatever. But if you're really worried just make up a cheap retainer.
_________________ mlm
|
|
|
|
 |
BlueSuzy

az supporter
Joined: Sun May 04, 2008 11:30 pm Posts: 9716 Location: NSW
Vehicle: SJ51 LWB, SJ70 SWB
|
 Posted: Sun Jul 24, 2011 7:51 am |
|
|
Retain one end of the springs.
Using missmatched shocks, eg, shock too long, your coil will pop out of its place.
_________________ BlueSuzy wrote: I'm over the G16b's.
|
|
|
|
 |
brockysvl
Joined: Wed Jul 20, 2011 9:21 am Posts: 5 Location: Sydney
|
 Posted: Sun Jul 24, 2011 8:05 am |
|
|
blue suzy and sierra dan if you've got coilys what height and type springs do you run in the back. I've read that the LH rear and RH rear coils contain different amounts of coils? Are all sierra coils tapered?
|
|
|
|
 |
christover1

az supporter
Joined: Tue Jul 15, 2008 11:30 pm Posts: 8203 Location: Melbourne
Vehicle: Pajero 91 NH 3.0 SWB
|
 Posted: Sun Jul 24, 2011 8:05 am |
|
|
[flash width=480 height=385]http://www.youtube-nocookie.com/v/LG_kFRB0pR0.swf[/flash]
|
|
|
|
 |
brockysvl
Joined: Wed Jul 20, 2011 9:21 am Posts: 5 Location: Sydney
|
 Posted: Sun Jul 24, 2011 8:19 am |
|
|
thanks for the link. Is this just a common problem for coilys with this amount of offroad mods?
|
|
|
|
 |
BlueSuzy

az supporter
Joined: Sun May 04, 2008 11:30 pm Posts: 9716 Location: NSW
Vehicle: SJ51 LWB, SJ70 SWB
|
 Posted: Sun Jul 24, 2011 8:20 am |
|
|
Tapered?
Either your coils are too short or your shocks are too long.
I don't have coils but i know how to fix a coil falling out..
_________________ BlueSuzy wrote: I'm over the G16b's.
|
|
|
|
 |
christover1

az supporter
Joined: Tue Jul 15, 2008 11:30 pm Posts: 8203 Location: Melbourne
Vehicle: Pajero 91 NH 3.0 SWB
|
 Posted: Sun Jul 24, 2011 8:22 am |
|
brockysvl wrote: thanks for the link. Is this just a common problem for coilys with this amount of offroad mods?
Vitaras can do it too,
as can any coiled car that has too long shocks for its coil length.
Spring should still have tension on it, at full droop.
You do not have the required permissions to view the files attached to this post.
|
|
|
|
 |
christover1

az supporter
Joined: Tue Jul 15, 2008 11:30 pm Posts: 8203 Location: Melbourne
Vehicle: Pajero 91 NH 3.0 SWB
|
 Posted: Sun Jul 24, 2011 8:23 am |
|
|
Coils could be shagged?
A quick fix could be coil spacers.
Or limitting straps so it dont droop so far.
|
|
|
|
 |
SierraDan

az supporter
Joined: Fri Feb 04, 2011 10:55 pm Posts: 9348 Location: Newcastle
Vehicle: G13BB Jimny
|
 Posted: Sun Jul 24, 2011 8:24 am |
|
|
I'd say your shocks are too long for your set up. So your axle is articulating as far as the arms will let it go which is further than your spring is long so it jumps out.
Retain the springs or get shorter shocks to limit the travel or make limiting straps.
As far as I'm aware if you have that amount of unrestricted travel on the coilys the diff mounts rip off. That's a worse issue.
_________________ mlm
|
|
|
|
 |
monley

az supporter
Joined: Wed Nov 24, 2010 7:58 am Posts: 11092 Location: Mandurah.W.A.
Vehicle: 84 LWB NT
|
 Posted: Sun Jul 24, 2011 8:31 am |
|
My coil fell out today to 
_________________ Tell my arse, he actually gives a crap!
|
|
|
|
 |
alien
Joined: Wed Mar 24, 2010 10:30 pm Posts: 16343 Location: Perth
Vehicle: '92 Sierra, 1.6efi, SPOA, 31s.
|
 Posted: Sun Jul 24, 2011 8:54 am |
|
|
just hose clamp the coild in place at the top =)
_________________ 
|
|
|
|
 |
monley

az supporter
Joined: Wed Nov 24, 2010 7:58 am Posts: 11092 Location: Mandurah.W.A.
Vehicle: 84 LWB NT
|
 Posted: Sun Jul 24, 2011 9:38 am |
|
Notice any thing wrong here?!?! 
_________________ Tell my arse, he actually gives a crap!
|
|
|
|
 |
christover1

az supporter
Joined: Tue Jul 15, 2008 11:30 pm Posts: 8203 Location: Melbourne
Vehicle: Pajero 91 NH 3.0 SWB
|
 Posted: Sun Jul 24, 2011 9:42 am |
|
monkey wrote: Notice any thing wrong here?!?! 
LOL I can see the marks where it landed
|
|
|
|
 |
Fatzook

az supporter
Joined: Sat Oct 27, 2007 11:30 pm Posts: 14977 Location: The Hills
Vehicle: Vitara, NGV
|
 Posted: Sun Jul 24, 2011 9:49 am |
|
monkey wrote: Notice any thing wrong here?!?! 
Yep. Your jimny has a sierra badge on it 
_________________ 2013 GV 1998 SV420 ute
|
|
|
|
 |
monley

az supporter
Joined: Wed Nov 24, 2010 7:58 am Posts: 11092 Location: Mandurah.W.A.
Vehicle: 84 LWB NT
|
 Posted: Sun Jul 24, 2011 9:51 am |
|
Fatzook wrote: monkey wrote: Notice any thing wrong here?!?!  Yep. Your jimny has a sierra badge on it 
 Factory badge to 
_________________ Tell my arse, he actually gives a crap!
|
|
|
|
 |
|