[sicktara]

due to bigger tires i need to lift the vitara, and cut some guards

im not doing a body lift, will cause to much fuss and i think they look untidy.

any way, and one have some springs laying around to measue the inside diameter so i can make some spacers? not going to pay 100 dollars for a 12 dollar peice of nylon.

cheers jordan

[Gwagensteve]

I'd say a body lift is tidier and less fuss than cutting guards, but each to their own.

I reckon body work is a time consuming PITA.

Steve.

[stocker]

Gwagensteve wrote:

I'd say a body lift is tidier and less fuss than cutting guards, but each to their own.

I reckon body work is a time consuming PITA.

Steve.

X2 on that.

either that or lift it properly... spring spacers will only limit your flex.

[got_bar_work]

40 mm bump stops in the rear will clear 31' on +10 rims with a little trim
Unless u go forward on the front there is heaps of fire wall loving to be done
If I was u I would go new springs

[SQUIRREL]

I have spacers fitted - 30mm
If you like I can measure them
They would be easy enough to make out of steel or alloy
But check eBay , there only like &50 or so
Personally I'd change springs and go they right way
First and flip the strut top and see how much room you have.

[sicktara]

already got new springs guys still rub