It is currently Tue Jul 28, 2026 1:07 am
Board index » Talking About Stuff » Suzuki Talk



Post new topic Reply to topic  [ 14 posts ] 
Author Message

Offline

Joined: Thu Sep 08, 2011 11:53 am
Posts: 26
Location: brisbane

Post Posted: Tue Nov 29, 2011 4:51 am 
Reply with quote Top  
I have a Sierra and the engine is playing up and I cannot work it out. It has been running a bit rough the last few weeks but nOt too bad and now it starts ok and revs fine but as soon as I out it into gear and take off it coughs and splutters and stalls ever time. It's 13ba engine any suggestions on what it is?

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Wed Jan 14, 2009 10:30 pm
Posts: 1441
Location: Around the corner
Vehicle: 1995 Sierra 1.3

Post Posted: Tue Nov 29, 2011 5:00 am 
Reply with quote Top  
Possibly some crap in carby - clean out crap from carby and possibly replace fuel filter if it hasn't been changed for a while.

http://auszookers.com/index.php?name=Fo ... 984#503984

 Profile WWW  

Offline

Joined: Tue Jul 27, 2010 6:17 am
Posts: 232
Location: NSW

Post Posted: Tue Nov 29, 2011 5:15 am 
Reply with quote Top  
x2 on fuel filter.

_________________
91Sierra; 2in lift; 2inBL; 6.5s; 31muds;

 Profile  

Offline

Joined: Thu Sep 08, 2011 11:53 am
Posts: 26
Location: brisbane

Post Posted: Tue Nov 29, 2011 6:56 pm 
Reply with quote Top  
Thanks guys will try that today and see how it goes

 Profile  

Offline

Joined: Thu Sep 08, 2011 11:53 am
Posts: 26
Location: brisbane

Post Posted: Wed Nov 30, 2011 2:08 am 
Reply with quote Top  
Ok gave that a go cleaned out the fuel replaced the filter runs well on idle and Erving but as soon as load is put on it shudders and coughs then stalls. Found that if I either push the gear stick had to the drivers side or if I grab the engine and pull it to drivers side it do this. Possibly when the engine twists it wants to stall like this hence when I go forward it stalls but if I run in reverse it dose now? Any suggestions now I'm all ou of ideas

 Profile  

Offline
az supporter
az supporter

Joined: Thu Nov 05, 2009 10:30 pm
Posts: 5319
Location: Canberra
Vehicle: 4wd

Post Posted: Wed Nov 30, 2011 2:28 am 
Reply with quote Top  
Sounds like your grabbing third and not first.
Try starting off in second and see if that helps.

_________________
Watch out or you'll get sued.

 Profile  

Offline

Joined: Thu Sep 08, 2011 11:53 am
Posts: 26
Location: brisbane

Post Posted: Wed Nov 30, 2011 3:17 am 
Reply with quote Top  
Nah I'm pretty machenicaly minded it's when u grab the whole engine and pull it drivers side over so like the engine has load when I'm taking off and it dose it then and when I put pressure on the stick which twists the gearbox slightly it dose the same thing. It dose it in any gear I take off except reverse for some reason so all forward gears. Go figure....?

 Profile  

Offline
User avatar

Joined: Sun Mar 22, 2009 10:30 pm
Posts: 1273
Location: Whangarei,N.Z.

Post Posted: Wed Nov 30, 2011 3:38 am 
Reply with quote Top  
I would say an electrical connection of some sort has come loose and the movement of the engine causes it to lose contact, stalling the engine.

 Profile  

Offline
az supporter
az supporter

Joined: Thu Nov 05, 2009 10:30 pm
Posts: 5319
Location: Canberra
Vehicle: 4wd

Post Posted: Wed Nov 30, 2011 3:41 am 
Reply with quote Top  
Sorry I misread your post.
Check your engine mounts.

_________________
Watch out or you'll get sued.

 Profile  

Offline
User avatar

Joined: Fri Sep 02, 2011 6:38 am
Posts: 693
Location: Singo
Vehicle: SJ70 1993

Post Posted: Wed Nov 30, 2011 8:49 am 
Reply with quote Top  
I had same problem and it was a dodgey coil. It started as load in reverse would stall then after awhile it did it to first. The bad coil not making a strong enough spark for it to kick over underload (what my brother sad i think). New coil in runs like a dream

Hope that helps

_________________
Lock, Drop and roll

 Profile  

Offline

Joined: Thu Sep 08, 2011 11:53 am
Posts: 26
Location: brisbane

Post Posted: Wed Nov 30, 2011 11:43 am 
Reply with quote Top  
ok cool thanks shiv, that sounds about right ill have a look at replacing the coil and maybe even leads they look a bit old and see how it goes thanks

 Profile  

Offline
User avatar

Joined: Fri Sep 02, 2011 6:38 am
Posts: 693
Location: Singo
Vehicle: SJ70 1993

Post Posted: Thu Dec 01, 2011 2:27 pm 
Reply with quote Top  
Yeah i did leads aswell

_________________
Lock, Drop and roll

 Profile  

Offline

Joined: Thu Sep 08, 2011 11:53 am
Posts: 26
Location: brisbane

Post Posted: Mon Dec 05, 2011 10:43 am 
Reply with quote Top  
Hey shiv wOrked like a charm! Replaced the coil and leads and drives like a dream! Thanks a lot guys the zook lives another day

 Profile  

Offline
User avatar

Joined: Fri Sep 02, 2011 6:38 am
Posts: 693
Location: Singo
Vehicle: SJ70 1993

Post Posted: Tue Dec 06, 2011 12:03 am 
Reply with quote Top  
Cheers no worries glad to help

_________________
Lock, Drop and roll

 Profile  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 14 posts ] 

Jump to:  


Who is online

Users browsing this forum: Google [Bot] and 478 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
Untitled Document


Untitled Document


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group :: Style based on FI Subice by phpBBservice.nl :: All times are UTC + 9:30 hours