[Oldmate28]

Hey all

Bought some second hand extractors and the damn things aren't a straight fit.
Has anyone bought any from eBay and found that they were a straight bolt up to the cat? No modifications required.
Maybe post a link?

Thanks fellas

[tsock0]

i bought some for a g16b off ebay $170 and they bolted straight up

u might have a different exhaust or some thing not 100%

[tsock0]

i bought some for a g16b off ebay $170 and they bolted straight up

u might have a different exhaust or some thing not 100%


they were wild cat brand

[Oldmate28]

No worries. Does the bottom of your front pipe (end of extractor) hang much lower than the chassis rails?

[SQUIRREL]

The ebay specials i bought come with a 3 bolt flange // not a problem if your replacing the rest but a PIA if using original system
they sit with no hangdown at all // really well fitting
do the ones on yours have the egr pipe ?? on number 4 ??

[Oldmate28]

Yeah mine have the same flange to bolt the factory cat up but they end about 3 inches short and hang down too low. Just finished booting up the factory cast headers and I cracked one of them ARGH!! Not my week.
I'm now committed to buying a new pair, hopefully I find some that bolt up to the stock system.

[SQUIRREL]

fortunately i have the tools and friends to assist in manufacturing my exhaust on the cheap using off the shelf parts , ( mandrel bends & so forth )
if you have access to some sort of welder the rest is relatively simple ,, trial fit , measure twice cut fourteen times ,,,,,
you may be able fit an adaptor or quietly drive to a muffler place and they can work their magic

did you need a replacement header & front pipe ??

[Oldmate28]

Yeah I might have to replace the header for the time being.

[SQUIRREL]

a 6 pack of jack daniels would seal the deal

[Oldmate28]

G16b efi header? If you have one available that would be a huge help mate.
6 pack no dramas.

[SQUIRREL]

g16b efi header with the dump section attached still ,, are you the same guy who picked up those white wheels?

[Oldmate28]

Last time I checked lol
I can pick up from uour work again if that helps? You working late on Thursday?
Wheels are nearly fitted by the way hehe

[SQUIRREL]

yeah dewd done deal ill bring it in tomozzo , my mornin tis a bit hectic but arvo is fine ,,, i finish 430 every day / sorry

[Oldmate28]

No dramas, I'll pop by tomorrow or Thursday. Thanks again.

[atari4x4]

If you're pushed for time Oldmate, I can swing past the bottle-O & then past Squirrel's place of employment before stopping off at the fun factory for the night.

shoot us a sms if you get stuck.

[gregwatkins75]

Not advertising but go see the guys at AAA exhaust, take the extractors and Jim the big guy will most definatley help you out and they do top quality work!

[Chop]

gregwatkins75 wrote:

Not advertising but go see the guys at AAA exhaust, take the extractors and Jim the big guy will most definatley help you out and they do top quality work!

Not bagging them, but my exhaust fell apart in the middle of bumfucksville that they installed

[gregwatkins75]

mmm. i had a good experience is all im saying...........

[Oldmate28]

Atari could you possibly do that for me? Would be easier than me trying to break out of jail for an hour.
Greg I did think of visiting AAA to see if they can help me out. Still need to replace my cracked header, the fumes are making me high!

[atari4x4]

yeah, no drama's oldmate.

squirrel, i'll swing past your work about 2.30 tomorrow arvo with a 6'er of JD tins