[pjtr17]

hey guys i replaced my snapped speedo cable a few weeks ago and i don't think its sitting properly in the transfer. i had my first drive of it yesterday no speedo until i just about got home and it worked for about 5 seconds. i removed the cable and tried turning it with it a screwdriver the wife said it was slightly moving?? is there something i'm missing is there a trick or something? any help or ideas greatly appreciated

cheers guys pat

[Madhatter]

Step 1: make sure cable is all the way home at BOTH ends. If this fails
Step 2 : pull off bottom end and put cordless dril on it.....speedo reads high, success box end is the failure.if not
Step 3: pull off speedo end, if you can't spin it speedo is the failure.
You'll probably find when you get both ends seated properly the problem will be gone

[pjtr17]

Righto I will try that one this afternoon thanks buddy

[94_brad_wt]

Hey guys just wondering if you have to take the dash claster apart to replace the cable
Cheers

[Blkfxx]

You don't have to take the cluster apart but you do have to pull the cluster out of the dash.

[pjtr17]

Yea I removed the cluster to swap it over, apparently you don't really need to but I found it easier, I think it would be easier to drop the steering column as I broke the clips on my trying to remove it! Good luck