[pookie_zookie]

Hey guys not sure if anyone has tried this but i have been told that a hilux bar will fit on the sierra quite easily due to the chassis apparently being the same width apart? Any ideas??
Thanx Mel

[Scrawny]

Smells like BS to me. Happy to be proven wrong

[shep]

i had to chop 170mm out of a hilux towbar to make it fit, bull bar would be the same i would reckon.

[pookie_zookie]

In one of the 4wd action mags there was a white sierra with wrangler flares and a TJM hilux bar on it, the only thing is the flares hang out on the sides a bit that it lines up with the flares.

[BUZOOKA]

it has been done on a coily dvd 123 of 3wd action have the dvd here but not sure if its off a lux or a cruiser havent watched it in a while but it can be done but the width of the bar will over hang by about 6 or so inchs

he had 6 inch bushwacker flares on and they filled out to the end of those nicley

didnt really if there was that much involved but just a looking point

cheers buzzy

[pookie_zookie]

Yea thats the one i was referring too. Just thinkin how common the hilux bars are and if it wasnt too hard to chop down a bit then maybe thats the way to go. Unless you guys have any other ideas?

[finlay113]

hilux chassis are narrower in the front than at the back. unsure as to how much though

[pookie_zookie]

Yea all sounding a bit too much. Ive organised a custom made bar now anyway since its not gonna cost anymore than an second hand ARB or TJM one.