Blake1191 wrote:
so just while i was mucking around with my bumper and laying around under the front of my vit noticed that both my cv boots were ripped

just wondering how hard to replace gona go down to repco tommorrow and see what they got.
Very greasy messy job.
I just did one.
Once I had removed the axle, I found it easier to remove the cup end, as it is clipped in with a ring around the lip, and the inner cv comes off with a circlip.
Couldn't work out how to get cv end off
If doing this way, do both inner and outer boots.
I used cable ties round boot,
to replace the original bits that were damaged.
One boot came off on last trip, so look for a a better solution, or better quality cable tie.
reco complete axles may be worth looking at, too.