[zuk85]

what are your opinions of wat this problem might be caused from.

with my old motor my car use too overheat when i was driving on the hwy, or when i was 4wding. normal driving was fine.

now when i pulled the motor out to put my new one in i noticed it dosnt have a thermostat. but also when i inspected what i could of the internal fins through the filler a few fins looks to have some crap in the top of them.
But when i run the hose through it the water seem to flow fine.

i might give this radiator i have a go with the new motor cause it has a thermostat.

[BlueSuzy]

Tip upside down and wash them out.

If they dont come out, it should be fine anyway.

Run the thermostat also.

[89_tintop]

Rip it Out and take it to a radiator shop..

You want them to clean it properly.. Or take the whole car and get the whole cooling system flushed..

I say you have a blocked radiator.

[losfer]

89_tintop wrote:

Rip it Out and take it to a radiator shop..

You want them to clean it properly.. Or take the whole car and get the whole cooling system flushed..

I say you have a blocked radiator.

X2

dont think running a hose through it will unblock it , get it done by a radiator shop.