[Murph987]

hey all,
so i have to pull out my front right suspension (its a coil over strut setup with 2in lift from standard) and i want to know if i will need a spring compressor to get it out.

any help would be cool.

Cheers,

Murph.

[Rusho]

It would help a lot if you do. It can be done without but it is a very dodgy exercise

[rob87]

i got a set if u want to buy them lol but i didnt need them when i put my 40mm suspension lift in... just jack it right up and oh get a set of rachet spanners would make the job heaps faster for undoing the top of the struts.... well when u jack it right up there is no load on the spring so you dont have to worry about there being load on it... soo good luck

[runtbase]

nar you dont need nothing jack the car up un bolt strut at top of tower then at diff and it will fall out. no special tools needed

[Ridge]

you wont need spring compressors to get the spring out.

put the car on chassis stands and have a jack under the diff, when you undo the nuts and bolts for the strut tower, you can lower the jack under the diff and the strut will come out.