[31zook]

So in the sierra steering department, there is a ball joint that sits at the end of the rod that goes to the steering box to the lower link. Mine is flogged out and giving my death wobbles, but no shop has a replacement. Im thinking i will need to buy another new one or do they press out?

I got another one off a mate for now but still wondering...

cheers

[royce]

once apon a time there was a thread about these, and they do make new ones

[Brett]

they press out but i just use two hammers if your never going to use it again

[v.w.dave]

They press out but can bend the arm/bar around it. I would use a little heat if you can.

[31zook]

cheers guy's i thought they pressed out but i wasn't sure or wanted to just stick a piece of cast under a press and eat it.

[Built4thrashing]

Just buy all new arms. complete setup was only $250 from suziworld here in vic. Wasn't aware you could replace just the balljoints. none of the parts places i spoke to knew it was able to be done.


B4T