[zukiduki]

I'm installing some extractors, just wondering if i need to use a torque wrench or if i just bang em on nice and tight.

If i need a torque wrench can anybody forward me the settings

[89_tintop]

there will be some torque setting in the manual for it but i always do them up till they are tight

[zuk85]

intake/ exhuast manifold nuts/bolts- 13.5 to 20 ft-lbs

and i guess do them in a sequence so it presses down evenly.

[unique_seek]

you dont need to use torque spec if your familiar with torquing up bolts on a car/4x4,but if your not I would recommend it!also you should tighten from the center out...don't forget your gasket and goo