[mudzookacoatsy]

hey all, checked my motor the other day at work and didnt like wat i found, i have a very very minor leaking head gasket and the compersion is down on the two middle pistons. 180psi on tha two end ones and 125psi on the two middle ones . is that bad ???? is it cheaper and easyer to just get another motor out of a zook or swift barina ect. or rebuild mine?

[LittleJeep]

it would be cheaper to change head gasket than to change the motor. a lot less stuffin around! and cheaper of cource.

[mudzookacoatsy]

ok but wat about tha compresion could that be part of tha head gasket or somwthing else?

[steak_knife]

mudzookacoatsy wrote:

ok but wat about tha compresion could that be part of tha head gasket or somwthing else?

More than likely the gasket, get the head serviced while it's off or get a good 2nd hand one..

[mudzookacoatsy]

o ok ill keep that in mind any thing else that i should do when its apart ?

[steak_knife]

Cam belt, front crank seal, thermostat, rad flush..

I could keep going..