[needmorelift]

doing my swivel hubs/bearing and put the bearing race thingo in the wrong way and now it wont come out. any creative ideas of getting the bastard out? was a mistake of not checking which way the bearing would sit

car is a 87 sierra

[royce]

Ask Bruce

if you get a brass drift (or anything softer than the race, wood will do and place it against one side horizontal and tap it with a hammer then the other side and work back and forward it will work its way out

[needmorelift]

cheers royce but i got it sorted using the stekky method...if a hammer doesnt work...get a bigger one

[shep]

hahahahaha. hay how come all the phones on elcho have stopped working since 2jays was here?

[needmorelift]

your net still works so what are you complaining about

[shep]

only about %20 of the time. it shows full signal but wont transmit stuff. not just me either, everybody is affected.

[needmorelift]

oh ok i'll ring him today and ask him.

[shep]

thanks mate, just tell him if he fixes it i will show him where the 40 series toyotas are hidden

[needmorelift]

he says he chopped it cos you wouldnt show him the 40s lol

nah he doesn't know why its not working. have you rung up them telstra call centres?

[shep]

needmorelift wrote:

he says he chopped it cos you wouldnt show him the 40s lol

nah he doesn't know why its not working. have you rung up them telstra call centres?

haha no one can ring a call center because the phones drop out every 5 min
and ya need to wait on hold for half a life time.

[steak_knife]

needmorelift wrote:

cheers royce but i got it sorted using the stekky method...if a hammer doesnt work...get a bigger one

peaceout